View
224
Download
5
Category
Preview:
DESCRIPTION
How to Set Up a Router in GNS3
Citation preview
How to Set Up a Router in GNS3
Open up GNS3 via the shortcut on the desktop
button and select the path to save the project in. Make sure you check Save nvrams and other
disk files, and Export router configuration files.
Drag a new Cisco 3700 Router under Node Types onto the design pane (blank whit
the middle of the program). Also, drag a new Cloud under Node Types into the design plane.
Right click on the new Cloud named C0, and click configure. This should bring u
configurator.
On the node configurator, click C0 under clouds. On the right hand side click the NIO TAP tab.
Under TAP interface enter tap0, then click the Add button.
the node configurator.
Click the Add a link button under the GNS3 toolbar,
the C0 node. When you click on the C0 node you should get a context menu that pops up. Click
the nia_tap:tap0 connection
To start the simulation, click the play button u
the terminal icon at the top under the GNS3 toolbar.
How to Set Up a Router in GNS3
via the shortcut on the desktop, and in the new Project Dialog click the
button and select the path to save the project in. Make sure you check Save nvrams and other
disk files, and Export router configuration files.
Cisco 3700 Router under Node Types onto the design pane (blank whit
the middle of the program). Also, drag a new Cloud under Node Types into the design plane.
Right click on the new Cloud named C0, and click configure. This should bring u
On the node configurator, click C0 under clouds. On the right hand side click the NIO TAP tab.
Under TAP interface enter tap0, then click the Add button. Click Okay to close out of
button under the GNS3 toolbar, and then click the R0 node and then
the C0 node. When you click on the C0 node you should get a context menu that pops up. Click
connection.
To start the simulation, click the play button under the GNS3 toolbar. To access the router, click
the terminal icon at the top under the GNS3 toolbar.
, and in the new Project Dialog click the
button and select the path to save the project in. Make sure you check Save nvrams and other
Cisco 3700 Router under Node Types onto the design pane (blank white section in
the middle of the program). Also, drag a new Cloud under Node Types into the design plane.
Right click on the new Cloud named C0, and click configure. This should bring up the node
On the node configurator, click C0 under clouds. On the right hand side click the NIO TAP tab.
Click Okay to close out of
click the R0 node and then
the C0 node. When you click on the C0 node you should get a context menu that pops up. Click
nder the GNS3 toolbar. To access the router, click
Recommended