View
82
Download
0
Category
Preview:
DESCRIPTION
Tutorial de como fazer um moleskine artesanal
Citation preview
11/15/12 Pedro Biz
1/9www.pedrobiz.com/diversos/molespobre/
Pedro Biz
Aqui no Brasil designers não tem condições de bancar moleskines. Sempre
temos que improvisar com blocos de rascunhos com espiral, ou usar páginas
versas de documentos. Até um guardanapo nos é útil (Hans Donner que o diga).
Pensando nestas pobres criaturas que ofereço um tutorial de um caderno aos
padrões de moleskine utilizando materiais ridiculamente baratos. Eis o
Molespobre.
Designers in Brazil can't afford moleskines. We always need to improvise with blank
pages of used notebooks and stuff like that. Even a napkin could be useful as sketch
page (Hans Donner knows). So thinking about this poor working class i provide you a
tutorial to make a notebook in moleskine standards using cheap materials. Here's
Molespobre (molespoor).
1. Materiais necessários/ things you'll need
- Papelão: 21,5x14cm
- TNT: 7x10cm
- 4 Folhas de papel: 36x28cm
- Linha e agulha
- Atílio (borrachinha, gominha...)
- Cola branca
- Cardboard
- PP Non-Woven Fabric
11/15/12 Pedro Biz
2/9www.pedrobiz.com/diversos/molespobre/
- 4 paper sheets
- Thread and needle
- Rubber band
- White Glue
OBS: A capa precisa ser cortada de forma que as ondas do papelão fiquem
paralelas ao lado menor, ou seja, a altura.
Obs.: On the cover, you'll have to keep the cardboard flutes in vertical orientation.
2. Dobrar ao meio/ folding
Dobre 3 vezes ao meio as quatro folhas de papel. Poder ser o papel que você
preferir. Só evite os acima de 180 de gramatura, pois dificulta a dobra e altera ao
tamanho da lombada.
Fold the 4 sheets in half 3 times. You can use any paper you want. Avoid paper
weights above 180 g/m2.
11/15/12 Pedro Biz
3/9www.pedrobiz.com/diversos/molespobre/
3. Marcar e Costurar/ marking and sewing
Esse é o passo mais chato, porém como é um caderno pequeno, o trabalho não é
tão complicado. Primeiro junte os blocos e marque os furos aonde passará a
linha. Com a agulha, faça os furos antes de começar a costurar. Então coloque a
linha na agulha e dê alguns nós no final da linha ed forma que fique uma
bolinha grossa o suficiente para não passar pelos furos dos blocos.
A costura está divida em 4 etapas (ABCD) conforme a imagem abaixo. Cada etapa
representa a costura de um bloco do caderno. Na etapa A, comece pelo furo
indicado pelo número 1 de forma que a agulha entre no bloco. Puxe a linha até
chegar ao nó. Sempre mantenha a linha esticada. Vá até o furo seguinte
apontado pela linha pontilhada (indica que a linha está passando por dentro do
caderno). No furo seguinte entre no caderno e saia pelo furo número 2.
Siga para a etapa B. Pegue o segundo bloco e entre com a agulha pelo furo 3.
Estique a linha de forma não deixar os bloco frouxos. Siga costurando como na
etapa anterior até o furo número 4. Antes de passar para o bloco de cima, passe a
agulha por dentro do nó que está no furo número 1 e suba para a terceira etapa.
Na etapa C, entre pelo furo número 5 e vá até o número 6 da mesma forma que
11/15/12 Pedro Biz
4/9www.pedrobiz.com/diversos/molespobre/
os outros blocos. Quando a agulha sair do bloco, passe-a por trás da linha do
furo 3 e suba para o último bloco.
Na etapa D, repita o procedimento da etapa C. No furo 8, passe a agulha duas
vezes pelo bloco debaixo (furo 5) e dê um nó para finalizar a costura. Corte o
excesso de linha.
This is the most boring step. But considering the small size of the notebook, it's not
that complicated. First, you'll have to put the sectons together and mark the holes
through which you'll pass the needle. With the needle, make the holes before you
start sewing. Then pass the thread through the needle hole and make enough knots
at the end of the line to make a big knot that will not pass through the notebook
holes.
The sewing is divided in 4 steps (ABCD) according to the image below. Each step
represents the sewing of one section of the notebook. Step A: insert the needle in the
hole labeled number 1 in such a way that the needle enters into the notebook. Pull the
thread till it gets to the knot, always maintaining the thread fully stretched out. Go to
the next hole marked by the dotted line (indicates that the thread is inside the
notebook). In the next hole the needle comes inside the notebook and comes out
through the hole labeled number 2.
Go to step B. Take the next section and stick the needle through hole number 3.
Tighten the thread to avoid leaving the sections loose. Keep sewing as in the prior
step till reaching hole number 4. Before going to the next step, thread the needle
inside the knot in hole number 1 and go to the third step.
Step C: stick the needle inside hole number 5 and go to number 6 in the same way as
the others sections. When the needle comes out of the section pass it under the
thread between holes 2 and 3 and go up to the last section.
Step D: repeat the steps in procedure C. In hole number 8, pass the needle twice
through the section below (hole labeled 5) and make a knot to finallize the sewing.
Cut off any excess thread.
11/15/12 Pedro Biz
5/9www.pedrobiz.com/diversos/molespobre/
4. Colar o TNT/ gluying the non-woven fabric
O TNT tem a função de firmar os blocos e prendê-lo à capa. Como na imagem:
(1) cole um lado; (2) depois passe cola na lombada; (3) e por fim, cole o outro
lado. Deixe o TNT bem esticado e liso no caderno.
Non-woven fabric will hold steady the books and fix them to the cover. Just like the
picture, (1) glue one of the sides (2) glue the notebook spine (3) glue the other side.
The non-woven fabric should be very tight and even.
11/15/12 Pedro Biz
6/9www.pedrobiz.com/diversos/molespobre/
5. Cortar o caderno/ cutting the notebook
Com ajuda da régua, corte os três lados do caderno que não foram costurados.
0,4cm de cada lado é um tamanho razoável para cortar todas as folhas. Evite
cortar mais que isso.
With a ruler, cut the 3 sides of the notebook you haven't sewn before. 0,4cm in each
side should be enough. Avoid cutting more than that.
6. Vincar a capa/ creasing the cover
Antes de começar esta etapa, certifique-se que as ondas do papelão estão
paralelas ao lado maior. Para garantir mobilidade para a capa sem estragar o
11/15/12 Pedro Biz
7/9www.pedrobiz.com/diversos/molespobre/
caderno, é preciso marcar as dobras antes da montagem final. Para tal, basta
colocar uma régua na orientação da onda e dobrar a folha. Acredito que 2cm para
cada direção a partir do centro é suficiente. Faça o vinco nos dois lados da capa.
Creasing the cardboard flutes, you guarantee the cover won't wrinkle each time you
open it. Before starting this step, make sure the cardboard flutes are in vertical
orientation. Place the ruler in the flute orientation and crease the cardboard in the
center. From the center, crease 2 cm to the left and 2 cm to the right in both sides of
the cardboard.
7. Colar a capa ao caderno/ sticking the cover to the notebook
Passe a cola branca no verso da primeira capa de forma uniforme. Não coloque
cola demais. Podes usar um pincel para maior precisão. Cole a primeira página
do caderno cuidando para deixar a margem igual dos 3 lados. Repita o
procedimento com a contracapa. Deixe o caderno fechado sob algum objeto de
não muito peso para não amassar o papelão e deixe secar com alguns minutos.
Glue the back of the first cover homogeneously. Don't put on too much glue. A brush
should help doing that with precision. Glue the first sheet of the notebook, leaving
margins of the same sizes on the 3 sides. Do it again on the back cover. Close the
11/15/12 Pedro Biz
8/9www.pedrobiz.com/diversos/molespobre/
notebook and put it under a book or another object. Make sure this object isn't too
heavy, or the cardboard will wrinkle. Leave it there to dry for a few minutes.
8. Colocar o atílio/ placing the rubber band
Para finalizar, use o atílio para manter o molespobre fechado e está pronto!
Espero que Este tutorial seja útil. Qualquer dúvida entre em contato comigo:
pedrotrg@gmail.com
Use the rubber band to keep you molespoor closed, and it's done!
I hope you'll find thist tutorial useful. In case of doubt, e-mail me:
pedrotrg@gmail.com
11/15/12 Pedro Biz
9/9www.pedrobiz.com/diversos/molespobre/
Recommended