Upload
eldiego1790
View
216
Download
1
Embed Size (px)
DESCRIPTION
akw
Citation preview
SAFETY DATA SHEET (93/112/EC)
1 Identification of the product and company
Ashland Specialty Chemical CompanyDrew Marine DivisionTRIATHLONSTRAAT 333078 HX RotterdamThe Netherlands
Ashland Specialty Chemical CompanyDivision of Ashland Inc. Telephone 010 479 01 44
Telefax : 010 479 71 35
Drew Marine Division
Emergency telephone nr.: +49 (0) 621 60-433 33 (24 h)
Supplier :
SLCC - A ™Product :
Product use : Corrosion control agent for treatment of steam lines.
2 Composition / Information on ingredients
All components contained in this product are included in the EINECS/ELINCS-inventory
Chemical name : % : CAS-nr : OEL : Symbol : R-phrases :
Aqueous solution containing:
Morpholine 25 - 40 110-91-8 35 mg/m3 H C 10-20/21/22-34 *1
Notes :
*1) Skin absorbtion may potentially contribute to the overall exposure to the product.
3 Hazards Identification
Symbol: CORROSIVE (C).
Risk phrases : Causes burns. Harmful by inhalation, in contact with skin and if swallowed. In use, mayform flammable/explosive vapour-air mixture.
Health Hazards
Routes of exposure : inhalation, skin absorption, skin contact.
Symptoms of exposure
Skin contact : severe irritation, reddening, dermatitis, burns.
Eye contact : severe irritation, redness, tearing, blurred vision, severe damage.
In case of inhalation : nasal and respiratory damage.
In case of swallowing : gastrointestinal irritation, nausea, vomiting, diarrhoea, sweating, weakness, headache.
Further information: Prolonged or repeated contact may cause: liver abnormalities, kidney damage. Dependingon the degree of exposure, periodical medical examination may be desirable.
First-aid Measures4
Skin contact : After contact with skin, wash immediately with plenty of water. Take off immediately allcontaminated clothing. Get medical attention immediately.
Eye contact : In case of contact with eyes, rinse immediately with plenty of water (at least 15 minutes)and seek medical advice. Continue treatment until medical assistance is provided.
Issue date : 19/04/2000 Page 1 of 5
Supersedes : 31/07/1998 Date printed : 13/11/2000
Ashland Specialty Chemical CompanyDrew Marine Division
SLCC - A ™
Ingestion : Rinse mouth. Give at least two glasses of water to drink (dilution). Do NOT inducevomiting. Get medical attention immediately.
Inhalation : Move person to fresh air. Avoid physical exertion of the victim. Get medical attentionimmediately.
Further information : Excessive inhalation may cause lung oedema, which may become manifest after a fewhours and which is aggravated by physical exertion: rest and hospitalization are essential.
Fire-fighting MeasuresNote: See also " Stability and Reactivity "
5
Extinguishing media
Suitable : water fog, alcohol resistant foam, powder, CO2.
NOT to be used : Regular foam may not be effective.
Special precautions : Use water to keep containers cool.
Protective equipment : Wear self-contained breathing equipment.
Explosion hazards : Vapours are heavier than air and may travel along the ground. Never use welding orcutting torch on or near drum, because the vapours can ignite explosively.
Fire hazards : Combustible
Hazardous decomposition products : CO2, CO, NOx, various hydrocarbons.
6 Accidental Release Measures
Protective equipment See section : 8. " Exposure controls/ Personal protection "
Small spills : Small spills and remainder can be absorbed on inert material like sand, earth, vermiculite,etc. Collect the spill in a suitable container. Flush the area with plenty of water.
Large spills : Persons without suitable protection must leave the area. Eliminate all sources of ignition.Provide for sufficient ventilation. Dike material to prevent spreading or run-off to openbodies of water. Collect the spill in a suitable container.
7 Handling and Storage
Handling : Use only in well ventilated areas. In use, may form flammable/explosive vapour-airmixture above 100 °C.
Storage : Keep container tightly closed and in a well ventilated place. Keep away from acids or/andstrong oxidizing materials. Keep at temperature not exceeding 35 °C.
8 Exposure controls/ Personal protection
Skin : Wear suitable gloves.Preferred material: Butyl rubber.
Eyes : Wear eye/face protection.Preferred type: Close-fitting safety goggles.
Respiratory tract :
9 Physical and Chemical Properties(not to be taken as product specifications)
In case of insufficient ventilation, wear suitable respiratory equipment, suitablerespirator/filter: K (green).
Appearance : Clear liquid.
Colour : colourless
Odour : Ammoniacal.
Boiling point : 100 °C (Initial).
Issue date : 19/04/2000 Page 2 of 5
Supersedes : 31/07/1998 Date printed : 13/11/2000
Ashland Specialty Chemical CompanyDrew Marine Division
SLCC - A ™
Freezing/melting point :
Explosion limits (%-vol) :
< - 4 °C.
lower : 2
upper :
Relative density (water = 1) : 1.01
Volatile component(s) :
Flash point : > 100 °C (PMCC)
Vapour pressure :
Auto-ignition temp. : 310 °C ( Morpholine )
16 mbar (20 °C Morpholine )
Evaporation rate : Slower than ether.
pH :
11.2
11.5
Solubility in water :
Not applicable.
Complete.
Further information :
10 Stability and Reactivity
Chemical stability : Stable.
Hazardous polymerization :
Specific vapour density: heavier than air.
Conditions to avoid :
Materials to avoid :
Hazardous decomposition products atnormal use :
No polymerisation possible.
None expected.
11
Excessive heat. Do not use sodium nitrite or other nitrosating agents together with thisproduct. Suspected cancer-causing nitrosamines could be formed.
Toxicological Information
strong mineral acids, strong oxidizing materials, metals like: aluminium,copper,brass andother copper alloys.
Acute toxicity
Oral LD50 (rat) : No specific test data available.
Dermal LD50 (rabbit) : No specific test data available.
Ecological Information12
Toxicity to water organisms : Morpholine:LC50 ( Rainbow Trout (salmo gairdneri), 96 hrs exposure )= 180-380 mg/l.EC50 ( Daphnia, 24 hrs exposure )= 115 mg/l.EC50 ( Algea, 96 hrs exposure )= 28 mg/l.EC50 ( bacteria ),16 hrs exposure )= >310 mg/l.
(Bio)degradability : (Bio)degradability : 93 % ( 25 days , OECD-Methode 301E ). Hence: Easily degradable.
BOD5 : No specific test data available.
COD : No specific test data available. COD ( theoretical )=2500 - 3000 mg O2 /g.
Additional information :
13 Disposal considerations
Waste disposal :
Partition coefficient: Log P(octanol/water) = -2.5. Hence: The tendency to bioaccumulateis low.
Spills and excess chemicals should be treated as chemical waste and disposed of inaccordance with all current special waste regulations. Contact a certified firm for properdisposal.
Issue date : 19/04/2000 Page 3 of 5
Supersedes : 31/07/1998 Date printed : 13/11/2000
Ashland Specialty Chemical CompanyDrew Marine Division
SLCC - A ™
14 Transport Information
Sea :
IMDG class :
UN-nr packing group :
8
2735 - III
IMDG page :
EmS / MFAG-table : 8-05 /
Road :
320
IMDG Shipping name :
ADR; class - item : 8 - 53c
ADR Shipping name : AMINES, LIQUID, CORROSIVE, N.O.S. ( Morpholine (aqueous solution) ).
Air :
ICAO/IATA-DGR
Transport symbol
8109-2
AMINES, LIQUID, CORROSIVE, N.O.S. ( Morpholine (aqueous solution) ).
The IATA instruction is subject to annual revision. Contact your local supplier
15 Regulatory Information
EU-labeling requirements : CORROSIVE (C).
Risk phrases : R 34, 20/21/22, 18
Causes burns. Harmful by inhalation, in contact with skin and if swallowed. In use, mayform flammable/explosive vapour-air mixture.
Safety phrases : S 23, 36, 45
Do not breathe fumes/vapour.Wear suitable protective clothing.In case of accident or if youfeel unwell, seek medical advice immediately (show the label where possible).
National Regulations
* Denmark
Registration nr. (Prod. reg DK) : 76292
National Regulations (DK) : The use by persons under the age of 18 years is not allowed (DK-Ministery of Labour;Publ. 594/92)
Issue date : 19/04/2000 Page 4 of 5
Supersedes : 31/07/1998 Date printed : 13/11/2000
Ashland Specialty Chemical CompanyDrew Marine Division
SLCC - A ™
* Germany
EU Waste disposal code : 160503
VbF - Classification (D) : Not applicable
WGK (Germany) : 2, hazard to water organisms ( According to Annex 4 of VwVwS 06/1999 )
Phosphor content : 0 %
Nitrogen content : Total nitrogen content 4 % (as N).
Zinc content : 0 %
* Finland
Product use : Corrosion control agent for treatment of steam lines.
SIC(TOL) standard industrialclassification :
611
KT - desired effect of the chemical : 8
16 Other information
Revisions in this data sheet:19/04/2000: Section(s):3, " Hazards Identification ";4, " First-aid Measures ";6, " Accidental Release Measures ";12, " Ecological Information ";15, " Regulatory Information "
SLCC - A ™ is a tradename of Ashchem I.P., Inc., used by Drew Divisions.
Important notice: This data sheet is a supplement to the technical instructions but does not replace them. The data are given in good faith based on information derivedfrom our knowledge of the product at the date of issue of this document. Each user is reponsible to determine that the product is suitable for the user's intendedapplication and that such usage complies with applicable legislative and administrative rules and guidelines. This data sheet may contain dotted lines (....), which mayindicate the missing of phrases in the computerized database. Please contact your local supplier.
Issue date : 19/04/2000 Page 5 of 5
Supersedes : 31/07/1998 Date printed : 13/11/2000