Cen-Tech Seven Function Digital MultimeterDial Replacement

This guide will show how to remove and replace the dial.

撰写者: Anna Kihm

Cen-Tech Seven Function Digital Multimeter Dial Replacement

© iFixit — CC BY-NC-SA zh.iFixit.com 1 / 6 页

介绍介绍

If the dial is stuck in any particular position it will be necessary to replace. This guide will show howto locate and replace the dial.

工具工具:Phillips #0 Screwdriver (1)

Flathead 3/32" or 2.5 mm Screwdriver (1)

章节章节:Cen-Tech Seven Function Multimeter

Dial (1)

Cen-Tech Seven Function Digital Multimeter Dial Replacement

© iFixit — CC BY-NC-SA zh.iFixit.com 2 / 6 页

步骤步骤 1 — Position Device

Place the meter face down, so theback panel and screws can be seen.

步骤步骤 2 — Remove Back Panel Screws

Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.

Cen-Tech Seven Function Digital Multimeter Dial Replacement

© iFixit — CC BY-NC-SA zh.iFixit.com 3 / 6 页

步骤步骤 3 — Remove Back Panel

Remove the back panel of thedevice by lifting upward.

Remove the battery from the meterbefore continuing.

步骤步骤 4 — Unscrew Motherboard

Remove the four 7mm Phillips screws holding the circuit board in place.

Cen-Tech Seven Function Digital Multimeter Dial Replacement

© iFixit — CC BY-NC-SA zh.iFixit.com 4 / 6 页

步骤步骤 5 — Remove Motherboard

Gently lift the circuit board awayfrom the device casing.

Remove the battery after removingthe back cover to reduce thechances of short-circuiting the circuitboard.

步骤步骤 6 — Locate Dial

The dial is located in the central partof the device.

Cen-Tech Seven Function Digital Multimeter Dial Replacement

© iFixit — CC BY-NC-SA zh.iFixit.com 5 / 6 页

To reassemble your device, follow these instructions in reverse order.

此文档最后生成于 2018-06-10 05:16:25 AM。

步骤步骤 7 — Remove Dial

Carefully remove dial from device bylifting upward.

Clean existing dial or replace ifnecessary.

Take care not to lose the small ballbearings.

Cen-Tech Seven Function Digital Multimeter Dial Replacement

© iFixit — CC BY-NC-SA zh.iFixit.com 6 / 6 页