Centralized RAN Configurations

Centralized RAN, Rel. CL10,Operating Documentation,Issue 01

Centralized RANConfigurations DN09158534Issue 01Approval Date 2014-06-23

The information in this document is subject to change without notice and describes only the productdefined in the introduction of this documentation. This documentation is intended for the use ofNokia Solutions and Networks customers only for the purposes of the agreement under which thedocument is submitted, and no part of it may be used, reproduced, modified or transmitted in anyform or means without the prior written permission of Nokia Solutions and Networks. The documen-tation has been prepared to be used by professional and properly trained personnel, and the cus-tomer assumes full responsibility when using it. Nokia Solutions and Networks welcomes customercomments as part of the process of continuous development and improvement of the documenta-tion.

The information or statements given in this documentation concerning the suitability, capacity, orperformance of the mentioned hardware or software products are given "as is" and all liability aris-ing in connection with such hardware or software products shall be defined conclusively and finallyin a separate agreement between Nokia Solutions and Networks and the customer. However,Nokia Solutions and Networks has made all reasonable efforts to ensure that the instructions con-tained in the document are adequate and free of material errors and omissions. Nokia Solutionsand Networks will, if deemed necessary by Nokia Solutions and Networks, explain issues whichmay not be covered by the document.

Nokia Solutions and Networks will correct errors in this documentation as soon as possible. IN NOEVENT WILL Nokia Solutions and Networks BE LIABLE FOR ERRORS IN THIS DOCUMENTA-TION OR FOR ANY DAMAGES, INCLUDING BUT NOT LIMITED TO SPECIAL, DIRECT, INDI-RECT, INCIDENTAL OR CONSEQUENTIAL OR ANY LOSSES, SUCH AS BUT NOT LIMITED TOLOSS OF PROFIT, REVENUE, BUSINESS INTERRUPTION, BUSINESS OPPORTUNITY OR DA-TA,THAT MAY ARISE FROM THE USE OF THIS DOCUMENT OR THE INFORMATION IN IT.

This documentation and the product it describes are considered protected by copyrights and otherintellectual property rights according to the applicable laws.

NSN is a trademark of Nokia Solutions and Networks. Nokia is a registered trademark of NokiaCorporation. Other product names mentioned in this document may be trademarks of their respec-tive owners, and they are mentioned for identification purposes only.

Copyright © Nokia Solutions and Networks 2014. All rights reserved

f Important Notice on Product Safety This product may present safety risks due to laser, electricity, heat, and other sources of

danger.

Only trained and qualified personnel may install, operate, maintain or otherwise handlethis product and only after having carefully read the safety information applicable to thisproduct.

The safety information is provided in the Safety Information section in the “Legal, Safetyand Environmental Information” part of this document or documentation set.

Nokia Solutions and Networks is continually striving to reduce the adverse environmental effects ofits products and services. We would like to encourage you as our customers and users to join us inworking towards a cleaner, safer environment. Please recycle product packaging and follow therecommendations for power use and proper disposal of our products and their components.

If you should have questions regarding our Environmental Policy or any of the environmental ser-vices we offer, please contact us at Nokia Solutions and Networks for any additional information.

Centralized RAN Configurations

2 DN09158534 Issue: 01

Table of ContentsThis document has 15 pages

Summary of changes..................................................................... 6

1 Single FSM Configuration.............................................................. 7 2 Two FSM Configuration................................................................10 3 Three FSM Configuration.............................................................13


Issue: 01 DN09158534 3

List of FiguresFigure 1 Flat 4 cell (FRHD or FRIG) configuration with single FSMF.................7Figure 2 Flat 6 cell (FRHD or FRIG) configuration with single FSMF.................8Figure 3 Flat 6 cell (FRGS) configuration with single FSMF...............................8Figure 4 Flat 4 cell (2 cells per FRHD or FRIG) configuration with single FSMF.

9Figure 5 Flat 4+4 cell (FRHD or FRIG) configuration with two FSMFs............. 11Figure 6 Flat 4+4 cell (FRGS) configuration with two FSMFs...........................11Figure 7 Flat 6+6 cell (1 or 2 cell per FRHD or FRIG) configuration with two

FSMFs................................................................................................ 12Figure 8 Flat 4+4+4 cell (FRHD or FRIG) configuration with three FSMFs...... 14Figure 9 Flat 4+4+4 cell (FRGS) configuration with three FSMFs....................15


4 DN09158534 Issue: 01

List of TablesTable 1 CL10 Single FSM Configuration Summary...........................................7Table 2 CL10 Single FSM Configuration Radio Details.....................................7Table 3 CL10 Two FSM Configuration Summary............................................ 10Table 4 CL10 Two FSM Configuration Radio Details...................................... 10Table 5 CL10 Three FSM Configuration Summary......................................... 13Table 6 CL10 Three FSM Configuration Radio Details................................... 13


Issue: 01 DN09158534 5

Summary of changesChanges between document issues are cumulative. Therefore, the latest documentissue contains all changes made to previous issues.

Note that the issue numbering system is changing. For more information, see Guide toWCDMA RAN and 1-HSPA Documentation.

Changes between issues 01 DRAFT (2014-02-28) and 01 (2014-06-23)Three FSM Configuration

• One new configuration added.• FSM configuration radio details added.

Two FSM Configuration

• Two new configuration added.• FSM configuration radio details added.

Single FSM Configuration

• Three new configurations added.• FSM configuration radio details added.

Summary of changes Centralized RAN Configurations

6 DN09158534 Issue: 01

1 Single FSM ConfigurationTable 1 CL10 Single FSM Configuration Summary

Configuration CL10 Support

LTE Bandwidth 10 MHz

LTE Bands Band 1 (2100 MHz)

Band 4 (2100/1700 MHz)

Band 7 (2600 MHz)

Flexi System Module 1 FSMF with 2 FBBAs

Flexi Radios FRGS (2100 MHz)

FRHD (2600 MHz)

FRIG (2100/1700 MHz)

RF Chaining No

RP3-01 Data Rate 6 Gbps (8x)

Sync Source GPS only

Table 2 CL10 Single FSM Configuration Radio Details

Flexi Radio Type Maximum power [W]

FRGS (2100 MHz) FRM 3TX (6 antenna ports) 80

FRHD (2600 MHz) RRH 4TX (4 antenna ports) 30

FRIG (2100/1700 MHz) RRH 4TX (4 antenna ports) 60 (2TX) or 30 (4TX)

Figure 1 Flat 4 cell (FRHD or FRIG) configuration with single FSMF

ANT 2 ANT 1ANT 3ANT 4

RX3�EXT RX1�EXT

RET

EAC LMP OPT IF�3 OPT IF�2 OPT IF�1

PA UNIT

CLASS�1

LASER�PRODUCT

Sector�2

Sector�4

Sector�3

Sector�1

Centralized RAN Configurations Single FSM Configuration

Issue: 01 DN09158534 7

Figure 2 Flat 6 cell (FRHD or FRIG) configuration with single FSMF


RX3�EXT RX1�EXT

RET


PA UNIT

CLASS�1

LASER�PRODUCT

Sector�4

Sector�6

Sector�5

Sector�1

Sector�2

Sector�3

Figure 3 Flat 6 cell (FRGS) configuration with single FSMF

Sector�6

Sector�5

Sector�1

Sector�2

Sector�3

Sector�4

Single FSM Configuration Centralized RAN Configurations

8 DN09158534 Issue: 01

Figure 4 Flat 4 cell (2 cells per FRHD or FRIG) configuration with single FSMF

Sector�3


RX3�EXT RX1�EXT

RET


PA UNIT

CLASS�1

LASER�PRODUCT

Sector�2 Sector�1

Sector�4

Centralized RAN Configurations Single FSM Configuration

Issue: 01 DN09158534 9

2 Two FSM ConfigurationTable 3 CL10 Two FSM Configuration Summary



LTE Bands Band 4 (2100/1700 MHz)

Band 7 (2600 MHz)

Flexi System Module 2 FSMFs with 2 FBBAs


FRHD (2600 MHz)

FRIG (2100/1700 MHz)

RF Chaining No

RP3-01 Data Rate 6 Gbps (8x) (Inter-FSM )

6 Gbps (FSM to RRH)


Table 4 CL10 Two FSM Configuration Radio Details





Two FSM Configuration Centralized RAN Configurations

10 DN09158534 Issue: 01

Figure 5 Flat 4+4 cell (FRHD or FRIG) configuration with two FSMFs


RX3�EXT RX1�EXT

RET


PA UNIT

CLASS�1

LASER�PRODUCT

Sector�3

Sector 7

Sector�4

Sector 8Sector�5

Sector�1

Sector 6

Sector�2

Figure 6 Flat 4+4 cell (FRGS) configuration with two FSMFs

Sector�2

Sector�3

Sector 7

Sector�4

Sector 8Sector�5

Sector�1

Sector 6

Centralized RAN Configurations Two FSM Configuration

Issue: 01 DN09158534 11

Figure 7 Flat 6+6 cell (1 or 2 cell per FRHD or FRIG) configuration with two FSMFs


RX3�EXT RX1�EXT

RET


PA UNIT

CLASS�1

LASER�PRODUCT

Sector�2 Sector�1

Sector�6

Sector 12Sector�7

Sector 9

Sector 4Sector 3 Sector 5

Sector�8

Sector 10 Sector 11

Two FSM Configuration Centralized RAN Configurations

12 DN09158534 Issue: 01

3 Three FSM ConfigurationTable 5 CL10 Three FSM Configuration Summary



LTE Bands Band 1 (2100 MHz)

Band 4 (2100/1700 MHz)

Flexi System Module 3 FSMF with 2 FBBAs


FRHD (2600 MHz)

FRIG (2100/1700 MHz)

RF Chaining No

RP3-01 Data Rate 6 Gbps (8x) (Inter-FSM )

6 Gbps (FSM to RRH)


Table 6 CL10 Three FSM Configuration Radio Details





Centralized RAN Configurations Three FSM Configuration

Issue: 01 DN09158534 13

Figure 8 Flat 4+4+4 cell (FRHD or FRIG) configuration with three FSMFs


RX3�EXT RX1�EXT

RET


PA UNIT

CLASS�1

LASER�PRODUCT

Sector�1

Sector 5

Sector 9 Sector 12

Sector 8

Sector 4

Sector�2

Sector 3

Sector 6

Sector 7

Sector�10

Sector�11

Three FSM Configuration Centralized RAN Configurations

14 DN09158534 Issue: 01

Figure 9 Flat 4+4+4 cell (FRGS) configuration with three FSMFs

Sector 5

Sector 9 Sector 12

Sector 8

Sector 4

Sector�2

Sector�3

Sector�6

Sector�7

Sector�10

Sector�11

Sector�1

Centralized RAN Configurations Three FSM Configuration

Issue: 01 DN09158534 15

Documents

Centralized RAN Configurations