We have observed that the because of the console/ membrane
problem the DTS is not working as a result school is not able to
use the Smart Class application.
Solution Approach:
To figure out an option to start the DTS while the console/
membrane is not working, without much of changes
Objective:
Simple to operateCost effectiveNo further dependency
Spare/component easily available
Problem Statement
Solution:
Yes it is possible to switch on the DTS while the console
membrane is not working.
To do this we have to follow the 4 steps as mentioned below
Step1: Disconnect the UPS power cable from the console
Step2: Connect the 2 pin push button switch with the UPS
power
Step3: Select the Projector power option from main menu
[projector] and reset to Direct Power On option
Step4: Go to CPU BIOS and select the Resume by USB 2.0 option to
start the CPU as soon as the power is on
Proposed Solution
Step1: Disconnect the UPS power cable from the console or ver
2.0 or 3.0
Cable connectionFrom UPS to Console UPS to Console Cable
Connection
Step2: Connect the 2 pin push button switch with the UPS
power
Push Button SwitchIntegration of Touch Button Switch
Step3: Select the Projector power option from main menu
[projector] and reset to Direct Power On option
Setting to be done in the projector Projector Setting
Step4: Go to CPU BIOS and select the Resume by USB 2.0 option to
start the CPU as soon as the power is on
Enabling the option to resume by USB in the CPU BIOSCPU BIOS
Setting
