F

F

F

F

F

FF

FFF

J J J J

J J J J J

JT

J

J J J

J J J J

TJ

TJ

J

TJ

+48"-

GF

CI

+48"-

GF

CI

+48"-

GF

CI J

T

GF

CI

GF

CI

+48"-GFCI+48"-GFCI

AA

FF

F

F

F

AA A A A A

A AA A

A

A

J J

J

J J

J

J

JJ J J

J

J J J J J J

J JJ

JJ

F

F

FF

J J

JJJ J J J J J J

JJ

JJ

J J J

JJ

J

GF

CI

A

A

A

A

F

GENERAL PLAN NOTES

ALL LIGHT FIXTURES INSTALLED IN SUSPENDED CEILINGS MUST BE FASTENED TO CEILING FRAMING MEMBERS PER NEC 410.36B.

SEAL CONDUITS ENTERING BOXES OF SOUND WALLS WITH RTV SILICONE SEALANT.

CONDUIT ROUTED THROUGH THEATER DEMISING WALLS WILL NOT BE ALLOWED. ONLY PENETRATIONS OF AUDITORIUM BACK WALLS AND SCREEN WALLS INTO CORRIDORS AND PROJECTIONS BOOTHS WILL BE PERMITTED. MAKE CONDUIT PENETRATIONS THROUGH SOUND WALLS AS FOLLOWS: CUT GYPSUM BOARD WITH CIRCULAR SAW 3/4" MAXIMUM DIAMETER LARGER THAN CONDUIT SIZE. USE 1/2" BACKER ROD AND CAULK ANNULAR SPACE FULL WITH ACOUSTICAL SEALANT. PROVIDE METAL ESCUTCHEON WITH LOCK-NUT ON BOTH SIDES AND SEAL AT CONDUIT AND WALL WITH ACOUSTICAL SEALANT.

REFER TO ARCHITECTURAL REFLECTED CEILING PLAN FOR EXACT LOCATION OF LIGHT FIXTURES.

WHERE KEYNOTE FOR A FIXTURE OR DEVICE IS INDICATED TO BE TYPICAL, THE KEYNOTE SHALL APPLY TO ALL LIKE TYPE FIXTURES OR DEVICES IN SPACE. IN EXAMPLE, WHERE TYPICAL KEYNOTE APPLIES TO 2'X4' FIXTURE, KEYNOTE SHALL APPLY TO ALL 2'X4' FIXTURES IN SPACE.

1.

2.

3.

4.

5.

GENERAL ELECTRICAL REQUIREMENTS1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

12.

ALL WORK SHALL BE DONE IN ACCORDANCE WITH LOCAL BUILDING CODE, NATIONAL ELECTRICAL CODE, NATIONAL FIRE PROTECTION CODE, EPA REGULATIONS, AMERICANS WITH DISABILITIES ACT, MINIMUM CONSTRUCTION STANDARDS, AND OCCUPATIONAL SATETY AND HEALTH ACT.

CONTACTOR SHALL INCLUDE ALL PERMITS, LABOR, PLANT MATERIAL, AND EQUPMENT TO PROVIDE FIRST CLASS AND COMPLETE INSTALLATIONS, AND ALL MATERIAL AND EQUIPMENT SHALL BE NEW UNLESS OTHERWISE SPECIFIED.

CONTRACTOR SHALL COORDINATE ROUGH-IN REQUIREMENTS AND FINAL CONNECTIONS TO EQUIPMENT WITH EQUIPMENT SUPPLIER. INSTALLATION SHALL MEET ALL CODES AND BE IN ACCORDANCE WITH EQUIPMENT MANUFACTURER'S RECOMMENDATIONS. VERIFY AND PROVIDE AS REQUIRED ALL DISCONNECTING MEANS, OVERLOAD PROTECTION, GROUNDING ETC. TO ASSURE PROPER INSTALLATION.

CONTRACTOR SHALL PROTECT ALL EXISTING WORK TO REMAIN, AND SHALL REPAIR ANY DAMAGE INCIDENTAL TO PERFOMANCE OF NEW WORK. INTERFERENCE WITH OWNER'S OPERATIONS OR INTERRUPTION OF SERVICES SHALL BE KEPT TO A MINIMUM AND FULLY COORDINATED WITH OWNER AND UTILITY AS APPLICABLE.

UNLESS SPECIFIED OR DIRECTED BY OWNER OTHERWISE, ALL EXISTING MATERIAL AND EQUIPMENT SHOWN OR REQUIRED TO BE REMOVED FROM EXISTING CONSTRUCTION AND NOT SHOWN TO BE REUSED, SHALL BECOME THE PROPERTY OF THE CONTRACTOR AND SHALL BE PROMPTLY REMOVED FROM THE SITE.

ACCEPTANCE OF WORK SHALL BE SUBJECT TO OWNER'S REPRESENTATIVE APPROVAL OF WORK IN PLACE AS WELL AS SHOP DRAWINGS AND SAMPLES OF MATERIALS AND EQUIPMENT WHICH SHALL BE CHECKED BY CONTYRACTOR BEFORE SUBMITTAL.

CONTRACTOR SHALL SUBMIT MARKED-UP CLEAN PRINTS OF RECORD CONDITIONS SHOWING CONCEALED DEVIATIONS FROM DESIGN.

CONTRACTOR SHALL KEEP PREMISES OF WORK AREA CLEAN DAILY, BROOM CLEAN AT PROJECT COMPLETION AND SHALLL REMOVE ALL REFUSE FROM SITE.

CONTRACTOR SHALL BECOME COMPLETELY FAMILIAR WITH EXISTING CONDITIONS BEFORE STARTING NEW WORK. CONCEALED CONDITIONS SHALL BE ADDRESSED WITH DUE CAUTION SUCH THAT UTILITIES AND SYSTEMS ARE PROTECTED.

CONTRACTOR SHALL CUT AND PATCH HOLES IN EXISTING CONSTRUCTION AS REQUIRED FOR NEW WORK WITH DUE CAUTION SUCH THAT STRUCTURAL, ACOUSTICAL, FIREPROOFING, AND WEATHER PROOF INTEGRITY IS MAINTAINED WITHOUT IMPAIRMENT.

CONTRACTOR SHALL WARRANTY ALL NEW WORK FOR A PERIOD OF ONE YEAR FROM DATE OF ACCEPTANCE AND SHALL REPAIR OR REPLACE ANY DEFCTIVE WORK INCLUDING MATERIAL, LABOR AND EQUIPMENT AT NO ADDITIONAL COST TO THE OWNER.

ALL WORK SHOWN ON DRAWINGS IS IN PART SCHEMATIC INTENDED TO CONVEY SCOPE OF WORK AND GENERAL LAYOUT. VERIFY ALL EXISTING CONDITIONS AND MAKE ADJUSTMENTS AS REQUIRED.

- 46P1

- 43P1

AUDITORIUM 14

140

AUDITORIUM 13

139

AUDITORIUM 12

137

AUDITORIUM 11

130

AUDITORIUM 10

128

AUDITORIUM 9

127

WOMENS

126MENS

129UNISEX

147

PARTY ROOM

138

- 47P1 - 47P1

- 3P2

SELF SERVE DRINKS

141

- 48P1

PROMENADE

133

STORAGE

135JANITOR

136

MDP

11- 9BF

- 7BF

11

- 16BF

- 14BF

11

- 8BD

- 6BD

11

- 7BC

11 - 8BC- 6BC

11 - 7BD- 5BD

2

- 58P1- 57P1

- 61P1

- 62P1

- 60P1

- 63P1

- 11BC- 12BC

- 11BD

- 12BD

- 20BF

- 13BF

3

33 3

3 3 3 3 3 3

- 76P1

4

4

4

4

- 19P1

- 70P1

- 21P1- 3,70P1

5 5 5 5 56 6 6 6 6 6 6 6

66

7

56 666

6

7 7 7 7 7 7VIA LC- 72P1

7 7VIA LC

- 69P18

WH

C

- 92P1WH

C

WH

D

- 91P1

3

3

3

3

3

3

3

- 93P1

30A/1P30A/1P

2#10, #10G., 1/2"C. 2#10, #10G., 1/2"C.7

7

E3.10

3

- 13P1

7

654321

654321

E

D

C

B

A

SHEET NUMBER

1100 Main StreetSuite 2200Kansas City, Missouri64105Phone : 816-842-7552Fax : 816-842-1302

DRAWINGS & SPECIFICATIONS REMAIN THE PROPERTY OF THE DESIGN PROFESSIONAL. COPIES OF THE DRAWINGS & SPECIFICATIONS RETAINED BY THE CLIENT MAY BE UTILIZED ONLY FOR THEIR USE & FOR OCCUPYING THE PROJECT FOR WHICH THEY WERE PREPARED & NOT FOR CONSTRUCTION OF ANY OTHER PROJECT

PROJECT #

E2.11

FIRST FLOORPLAN - POWER B

PERMIT SET

MAL

CO

TH

EATR

ES: O

WEN

SBO

RO

14

2700

CAL

UM

ET T

RAC

EO

WEN

SBO

RO

, KY

2017.11.06

17025

ELECTRICAL PLAN NOTES

1 MASKING MOTOR RECEPTACLE +18" AFF WITH (4)#14 THHN TO BOOTH FORMASKING CONTROLS. COORDINATE EXACT LOCATION WITH OWNER PRIORTO COMMENCING WORK.

2 PROVIDE 120V POWER IN WALL WITH LOCAL DISCONNECT FORCONNECTION FOR ELECTRIC WATER FOUNTAIN CHILLER. BRANCH CIRCUITTO BE GFCI PROTECTED. COORDINATE POWER REQUIREMENTS WITHEQUIPMENT PROVIDER BEFORE BEGINNING WORK.

3 AISLE LIGHT JUNCTION BOX RECESSED MOUNTED IN WALL AT 12"AFF ORRECESSED IN FACE OF RISER AS INDICATED ON PLAN. PROVIDE SINGLEGANG BOX WITH 2#12 WIRES FROM AISLE LIGHT TRANSFORMER IN BOOTH,RE: BOOTH ELEVATION. COORDINATE EXACT REQUIREMENTS WITHOWNERS VENDOR PRIOR TO BEGINING WORK.

4 J-BOX MOUNTED IN WALL. CONNECT HAND DRYER. COORDINATE EXACTLOCATION AND MOUNTING HEIGHT WITH ARCHITECT. 1400W, 120V.

5 PROVIDE 120V POWER AND DATA FOR LCD MONITOR. CONFIRM DATA TYPEWITH OWNER. RE: ARCHITECURAL ELEVATIONS FOR EXACT LOCATIONS.

6 PROVIDE J-BOX FLUSH MOUNTED IN WALL WITH 120V POWER AND MAKECONNECTION TO INTERIOR SIGNAGE. RE: ARCHITECTURAL ELEVATIONS.COORDINATE LOCATION AND POWER REQUIREMENTS WITH APPROVEDSIGN VENDOR SHOP DRAWINGS.

7 PROVIDE J-BOX FLUSH MOUNTED IN WALL WITH 120V CONNECTION FORPOSTER CASE. MAKE FINAL CONNECTION TO POSTER CASE. COORDINATEEXACT LOCATION AND MOUNTING HEIGHT WITH ARCHITECT.

8 PROVIDE J-BOX FLUSH MOUNTED IN WALL WITH 120V POWER AND MAKECONNECTION TO EXTERIOR SIGNAGE. RE: ARCHITECTURAL ELEVATIONS.COORDINATE LOCATION AND POWER REQUIREMENTS WITH APPROVEDSIGN VENDOR SHOP DRAWINGS.

1/8" = 1'-0"1

FIRST FLOOR - POWER B

Revision Schedule

# Date Description

3 2018.02.16 ADDITION

7 2018.07.17 DELTA 7