Upload
phamkhanh
View
215
Download
0
Embed Size (px)
Citation preview
Projekt 1.3.3 Klassering och
separation av fina partiklar
• Bygger på MinBaS Studie av nya tekniker
• För klassering av fina partiklar
• Vindsiktning: Comex och Hosokawa
• Tornado Airgrinder AB, MEFOS
• Selfrag AG ,
Principle of selective fragmentation
using HV pulsed power
electrodynamicelectrohydraulic
Water or Oil
Solid
Fragmentation by Explosion
Energy Balance
750 J / Pulse250 kV, 6 kA
200 ns
Water or Oil
Solids
Fragmentation by Compression
Energy Balance
6000-10‘000 J / Pulse
Fractures
20 kV, 100 kA
1-10ms
Completely liberated heavy minerals, 1-2 mm, oxidized and weathered surfaces distinctely preserved.
Completely liberated heavy minerals, 1-2 mm, ilmenite, garnet and cpx nearly in equal proportions.
Unweathered kimberlite rock Weathered cobbles of kimberlite
Diamondiferous KimberlitesJoint study with the Geological Survey of Finland
selFrag – Mineral Exploration
Sicomant
• Upprepade kontakter med potentiella
intressenter
• Yanmin Wang har besökt
försöksanläggningen I Ningbo
• Kunde ej utvecklas till ett projekt
THE SICOMANT MILL
operation1. (A) Filling unit. (B) Upper
container
2. (C) Closed system with vacuum pump
connected.
3. (D) Vertical tubes for free falling grains in
the sealed system.
(E) Mill house where the grains are crushed
in two steps. a. Ortogonal impact against
the rotor mill plates. b. Second impact
against the wall plates.
(F) Sealed tube for further transportation
of the crushed grains down to the lower
container.
4. (G) sealed lower container where the
material is collected. The container can
either be emptied if the process is finished
or exchanged with the upper container for a
second process.
Upper and lower container can change
places and serve the same purpose.
DE
F
G
A
B
C
THE SICOMANT MILL
testsSicomant mill has tested several materials.
• Talcum
• Mica
• Gypsum
• Coal, Hard Coal
• Sandstone
• Wood powders
• Nutrition minerals
• Calcium carbonates
• Magnetite
• Manganese
• Quartz
• Plus a number of other materials.
The screening can in certain cases be avoided through suitable
optimisation of the grinding energy and the mill plates surface
material and adjustment.
1.3.3 b. Luftklassering av
industrimineral
• Comex A/S vald som samarbetspartner
• Försöksanläggning I Kethy, Polen
• UCX-200 med bl a Insitec
• Deltagare: NCC Roads
• Omya AB
• SMA
• Nordkalk
NCC Roads AB
• Finmaterial från klassering av
bergartsmaterial, förbättring av material
avseende partikelstorleksfördelning och
mineralsammansättning
1.3.3 b. Resultat
• 5 rapporter varav 4 från Comex, en för
varje material
• 1 rapport från Ekström Mineral AB
angående bestämning av glimmer halt.
UCX
classifier
Feed transported
pneumatically
De-dusting in the first
separation zone
Low distance passage
along the rotor in the
second zone
Spiral outlet for air and
fines
No collisions between
stream trajectories
Resultat
• Mineralogisk undersökning
• Feed Biotit 22 och muskovit 10 %
• Prov 1 för fint
• Prov 2 Biotit 42 och Muskovit 15 %
• Prov 3 Biotit 36 och muskovit 13 %
• Prov 4 Biotit 20 och muskovit 10 %
Svenska Mineral AB
• Free lime in feed 12 %
• Free lime in fines about 20 % and 10 % in
coarse
• CaO very fine
1.3.3 a. Klassering och separation
– malning av hyttslam i Tornado.
• Samarbete SSAB MEROX och Metso
Minerals (Sala)
• Avvattning till “hård” filterkaka med
pressluftfilter 25 % H2O, typ VPA
• Vakuumfilter 31 %, kladdig kaka
• Tube press 21 % fukt
• Pilotförsök ej genomförda
Process Description:
1. A fan powered by electric motor creates an air stream.
2. Material is taken by the stream and flows into a cyclone-formed device.
3. Heavy vibrations and changes in radial-velocity disintegrate the material particles.
4. Fluids and the finest material fraction go out through the upper part.
5. Product runs out from the bottom of a cyclone.
FIGURE 1
Resultat
• Pressluftfiltrering ger filterkakor som är
tillräckligt hårda för att matas in i Tornado
för att där malas och torkas till önskad
fukthalt.
2.5.5 Coating och malning av
industrimineral med Hicom
• Charles Warman, presenterat 1985
Våtmalning
• MD Research
• Ludowici Australia Pty, Pinkenbaa
• Fokus på torrmalning och coating
• Försöksanläggning 25 KW
Up to 50G inside
the grinding
chamber
Power densities of
up to 2,000 kW per
m³ of grinding
chamber volume
Dry Grinding (Fine, Ultra-fine)
Wet grinding
Autogenous grinding
Attritioning
Mechanical alloying
Delamination
Agglomeration / De-
agglomertion
Coating© Hicom Technologies 2006-2009
Deltagare
• Nordkalk AB, Parfill 7
• Omyacarb 10
• Torrmalda med grinding aids
• Malning utan malhjälpmedel mycket svårt
• Stearat som coating
CONTROL
CABINET
CLASSIFIER
PRODUCT
FILTER
ENVIRONMENTAL
FILTER
BAG UNLOADER +
AIR TRANSPORT
SYSTEM
FEED
HOPPER
HICOM 25
MILL
© Hicom Technologies 2006-2009