7/25/2019 GAA 24350 AW11 IVb.pdf
3/11
event
no
event name
no event , use 'GOON' to scroll to next event
wrong door command or supervisor mode
Top of Car Inspection signal active
initialize run occurred
door could not close because of an obstacle
nudging runs occurred
new parameter was stored in EEPROM
passenger protection activated during normal run
passenger protection activated during continuous run
shut down mode
inspection run activated
profile velocity not reached during constant velocity open
phase( deviation > 5 Hz )
profile velocity not reached during constant velocity close
phase( deviation > 5 Hz )
actual velocity greater than dictated velo. at 10 mm before DFO(
deviation > 4 Hz )
actual velocity greater than dictated velo. at 10 mm before
DFC
act. velocity greater than creep open velo. at begin of
accel.
actual velocity greater than creep close velocity art begin of
ac-celeration (deviation > 1 Hz)
stored default parameter table into EEPROM
door state changes from closing to opening
-- NO EVENT --
-- NO EVENT --
Emergency Door Stop Button (EDS) activated
elapsed time after Installation run was activated
MCSS communication is broken
-- NO EVENT --
-- NO EVENT --
-- NO EVENT --
-- NO EVENT --
-- NO EVENT --
end of event logging list
![old.renyi.hu · !" # %$& '!)(* + %,!) - % . /10 24350 68790 :=@?BADCEC A FHG 0 IJ:5KMLN0 :O2BID:P35QSRT0JUWVXU%Y Y[Z4UW\4U]A@?^\XU_Za`1\XU_=Ebdce0#QP3fIJ:P3g0+h3gij:50+6%iakE0l35mX](https://img.pdfslide.tips/doc/110x75/5fa8d702db5c950ffd4e435b/oldrenyihu-10-24350-68790-badcec-a-fhg.jpg)
