ALIGMENTEQUIPMENT CONECTION STEP GENERATOR

FREQUENCYDIAL SETTING PROCEDURE

IF CONNECT INPUT OF IF GENESCOPE 1 465 Khz (1 KHz MOD.) TUNING GANS FULLY CLOSED T1 FOR MAX. OUTPUT. 2 REPEAT UNTIL NO FURTHER IMPROVEMENT

CAN USE MADE.MW BAND AM SIGNAL GENERATOR WHIT LOOP ANT.

OUTPUT METER (VTVM) ACROSS 8-0mm LOAD (FIG. 2).

3 515 KHz (1 Khz MOD.) TUNING GANS FULLY CLOSED. L 5 FOR MAX. OUTPUT.

TRACKING AM SIGNAL GENERATOR WHIT) 6 558 KHz (1 KHz MOD). TUNE TO SIGNAL L1 ON FERRITE BAR FOR MAX.LOOP ANT., OUTPUT METER (VTVM 7 1440 KHz (1 KHz MOD.) TUNE TO SIGNAL. CT1 FOR MAX. OUTPUT.

8 REPEAT STEPS 6 & 7 SEVERAL TIME.SW BAND AM SIGNAL GENERATOR TO ANT. THROUGH 9 5,8 MHz (1 KHz MOD TUNING GANS FULLY CLOSED. L6 FOR MAX. OUTPUT.

DUMMY LOAD (FIG. 4). 10 REPEAT 9.TRACKING AM SIGNAL GENERATOR TO ANT. THROUGH 11 6 MHz (1 KHz MOD.). TUNE TO SIGNAL L2 FOR MAX OUTPUT.

DUMMY LOAD (FIG. 4). 12 11 MHz (1 KHz MOD.). TUNE TO SIGNAL TC1 FOR MAX. OUTPUT.13 REPEAT STEPS 11 & 12.

FM IF CONNECT INPUT OF IF GENESCOPE TO C5THROUGH DUMMY LOAD (FIG. 3)

14 10,7 MHz (1 KHz MOD.). TUNING GANG FULLY CLOSED. T2 & L7 FOR MAX. SYMETRICAL RESPONSE (10,7 MHz AT THE CENTRE POINT).

15 REPEAT STEP 14.FM BAND FM SIGNAL GENERATOR TO ANT. TERMINALS 16 87.5 MHz (1 KHz MOD. ). TUNING GANS FULLY CLOSED. L4 FOR MAX. OUTPUT.

THROUGH 75 W ANT. MATCHING NETWORK. 17 108,25 MHz (1 KHz MOD.). TUNING GANS FULLY OPENED. CT4 FOR MAX. OUTPUT.OUTPUT METER (VTVM) ACROSS SHOW LOAD (FIG. 5)

18 REPEAT STEPS 3 & 4

TRACKING FM SIGNAL GENERATOR TO ANT. TERMINAL 19 88 MHz. TUNE TO SIGNAL. L3 FOR MAX. OUTPUT.THROUGH 75 W ANT. MATCHING NETWORK. 20 TUNE TO SIGNAL. CT3 FOR MAX. OUTPUTOUTPUT METER (VTVM) ACROSS 8 W LOAD (FIG. 5).

21 REPEAT STEP 6 & 7.