Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
i
�����������������������
���
ii
Improvement of Helium Sampling System in HTTR
Kenji SEKITA, Misao KUROHA , Koichi EMORI , Masaaki KONDO
Hiroshi OHUCHI and Masayuki SHINOZAKI
Department of HTTR
Oarai Research and Development Center
Japan Atomic Energy Agency
Oarai-machi,Higashiibaraki-gun,Ibaraki-ken
(Received January 7, 2008)
Graphite structures are used as the HTTR core internals. Graphite structures
have high heat resistant property but strength degrades easily by oxidization. To prevent the
oxidization of graphite structures, impurity concentrations in the helium coolant are
controlled strictly. The helium sampling system is installed to measure the impurity
concentrations in the helium coolant.
Seal-oil leakage occurred at the rod seal mechanism of gas compressor in helium
sampling system. The reasons are degradation of the seal material and contaminant abrasion
powder of the grand-packing. Thus, the material of the seal material was changed and
contaminant was decreased. A long term operation became possible by these
countermeasures. Moreover, reliable data can be obtained and efficient impurity control is
enabled due to renewal of data acquisition control computer of gas chromatograph mass
spectrometer and improvement of liquid nitrogen trap.
This report describes the improvement items of the helium sampling system.
Keywords: HTTR , Maintenance , Helium Sampling System , Impurity of Helium
Gas Compressor
Research Staff on Loan
�����������������������
���
iii���
����������������������� �������������������������������
iv
Contents
1. Introduction
2. Outline of helium sampling system
2.1 Primary Helium Sampling System
2.2 Secondary Helium Sampling System
3. Overhaul of gas compressor
3.1 Structures of gas compressor
3.2 Conditions of overhaul of gas compressor
3.3 Occurrence details of seal-oil leak
3.4 Investigation of cause of seal-oil leak
3.5 Counter measure
4. Improvement of Data Acquisition Control Computer
4.1 The point at issue
4.2 Function of renewal system
4.3 Method of software
4.4 Method of file definition
4.5 Result of renewal system
5. Improvement on Liquid Nitrogen Trap
5.1 Condition of the past
5.2 Method of renewal Liquid Nitrogen Trap
6. Conclusion
Acknowledgements
References
�����������������������
���
�������������������������������
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
���
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
18
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
���� �� � ����� �����
�����������������������
�������� ������������������
�����������������������
����
���� �� � ����� �����
�����������������������
�������� ������������������
�����������������������
����
���� �� � ����� �����
44
�����������������������
����
�����������������������
����
�����������������������
����
�����������������������
����
�����������������