8/13/2019 Megacel Afp 1 403

1/2

Lower initial pressure drop -

0.7" w.g.

Available in 99.99%

(IEST-RP-CC001.5 Type C Filter)

Lower susceptibility to damageduring normal operations (room

decontamination, spray-down, etc.)

Lower energy consumption through

reduction in needed fan motor

horsepower (40% lower)

Meets industry performance

requirements

ULPA filters with PTFE have beenplaced in service over the last 10

years with in-place failure rates

exceedingly lower than micro-

fiberglass media filters

Product Features Advantages Customer Benefits

Solution Features, Advantages, and Benefits

AAF MEGAcel I filter with Helior PTFE media provides the highest

efficiency at the lowest resistance in the air filtration industry.

Better Air is Our Business

Performance

Substantial

ENERGY SAVINGS

Keeps operating cost to a minimum

and increases process productivity

Reduced likelihood of filter failureduring in-place testing

8/13/2019 Megacel Afp 1 403

2/2

AAF has a policy of continuous product research andimprovement and reserves the right to change

design and specifications without notice.

10300 Ormsby Park Place Suite 600Louisville, Kentucky 40223-6169

www.aafintl.com

Customer Service 888.AAF.2003

Fax 888.223.6500

ISO Certified Firm

2011 AAF InternationaUSGBC Member logo is a trademark owned by the

U.S. Green Building Council and is used by permission.AFP-1-403C SUP MAR '11 QG 3M

Resilient synthetic substrate

Chemical resistant

Water resistance

Negligible off-gassing

Durability and tensile strength is 8X that

of standard micro-fiberglass media

No media degradation from alkaline,

acid, and organic substances

Media integrity maintained

Reduce labor expense through longer

life expectancy and reduction in

damage during handling

Cost savings from longer life

expectancy and fewer change-outs

caused by filter leakage

Reduced filter damages = cost savings

Improved yield and reduced likelihood

of contamination from the filter

Product Features Advantages Customer Benefits

Tapered aluminum separators

Media production, filter assembly,

testing, and packaging in an

ISO Class 7 environment

Optimizes pleat pack resistance

Eliminates potential for contamination

Product Features Advantages Customer Benefits

Figure A illustrates the finer diameter and more consistent

composition of Helior PTFE media when compared with

micro-fiberglass media in Figure B.

Figure A (10,000x) Figure B (10,000x) Figure C (5,000x) Figure D (5,000x)

Figure C clearly shows the broken glass fibers at the pleat

edge, while the fold of Helior PTFE media in Figure D

is intact.

Tapered separators ensure uniform airflow and

stability to the media pack.

Media

Construction

Conserves energy/cost reductions

Guaranteed high performance AAF

is the only HEPA/ULPA manufacturer

to fully manufacture filters in a Class

ISO 7 cleanroom