-
1OFFICE:panielova 1315/25, Praha 6, 163 00IO: 64940799DI:
CZ64940799
SHOWROOM:Sdlit Jantejn 39, Horn Dubenky588 52
SHADOWS PC929Suspension Light PC929
Components included with unit:
5x plastic grommet, 2x hex screw, 1x hex key, 3x wire connector
terminal, 5x light source, 5x glass shade, 5x wooden body, 1x metal
ceiling canopy with ceiling hanger, 5x silicone pad
Installation Steps:
1. Install the hanger for the metal ceiling canopy (fig. 1). -
With regard for various types of ceiling materials, we recommend
consulting an expert when securing the canopy hanger to the
ceil-ing. The manufacturer assumes no liability for incorrect
installation or defects in the material to which the canopy hanger
is to be se-cured.
Because the glass components of the light are hand-crafted,
there is some variation in the inner diameter of the individual
shades. Therefore, each shade is carefully matched to its
respec-tive wooden body prior to shipping. The correct match is
indi-cated with colored rubber bands. During assembly, care must be
taken to ensure that each shade is paired with the wooden body of
the corresponding colored rubber band (fig. 2b).
2. Light Assembly- Select one of the glass shades and its
corresponding wooden body. - Attach the glass shade to the wooden
body by pulling the power cord through the shade.- If the shade is
slightly misaligned, try carefully turning it on the wooden body,
or correct the misalignment with one of the silicone pads by
adhering it to the outer side of the wooden body so that it is
situated between the shade and body (fig. 2a). - Pull the power
cords of the individual lights through the metal ceiling canopy and
secure them using the plastic grommets. - Connect the light to the
building wiring. - Using the hex screws and the hex key, attach the
ceiling canopy to the ceiling hanger (fig. 1).
1. Install the hanger for the metal ceiling canopy (fig. 1). -
With regard for various types of ceiling materials, we recommend
consulting an expert when securing the canopy hanger to the
ceil-ing. The manufacturer assumes no liability for incorrect
installation or defects in the material to which the canopy hanger
is to be se-cured.
3. Restore power at the main circuit panel and ensure that the
light is working properly.
280
170
2000
400x 60
-
2Materials
Glass:The technological methods used in creating the light are
based on several hundred years of traditional Czech handmade glass
production. Respect for the material and its traditional production
is characteristic for Bro-kis. Imperfections in the glass are the
result of these technological methods and have no effect on the
quality or functionality of the light.Wood: wooden body made of
European oak (QUERCUS SPP)Wood is a natural material that reacts to
changes in relative humidity levels and temperature in the
sur-rounding environment. When the relative humidity is extremely
low (below 30%), the wood gradually dries out and cracks will
appear. Therefore, we recommend maintaining a relative humidity of
between 40-60% and a temperature of 15 to 25 degrees Celsius.
Cleaning The light may be cleaned with common cleaning agents.
Do not use solvents or abrasive cleaning agents (powders).
Prior to shipping, the functionality of each light and its
components is thoroughly tested. The manu-facturer assumes no
liability for the mishandling of products.
Technical support: [email protected]
1a
2a 2b
M4 screws
M4 screws
canopy cover
cealing rack
Use this holes for the fixing rack onto the ceiling.
-
1OFFICE:panielova 1315/25, Praha 6, 163 00IO: 64940799DI:
CZ64940799
SHOWROOM:Sdlit Jantejn 39, Horn Dubenky588 52
SHADOWS PC929Svtidlo visac PC929 Komponenty, kter jsou soust
balen:
5x plastov prchodka, 2x imbusov roub, 1x imbusov kl, 3x
pipojovac svorkovnice, 5x svteln zdroj, 5x sklenn stnidlo, 5x devn
montura, 1x kovov baldachn vetn drku, 5x siliko-nov oka
Montn postup:
Mont sm provdt pouze pracovnk sodbornou elektrotech-nickou
kvalifikac.Ped mont vypnte pslunm jistiem pvod elektrickho
proudu!Pi nedodren montnho nvodu vrobce neru za ppadn vznikl
kody!
Vnitn prmry jednotlivch stntek se mrn li; to je pirozenm
dsledkem run vroby sklennch st svtla. Ztoho dvodu je kad stntko ped
expedic peliv prov-no s pslunou devnou monturou. Sprvn kombinace je
vyznaena barevnmi gumikami. Pi kompletaci je proto nez-bytn dodret
shodnost barevnho oznaen sklennho stntka a devn montury (obr.
2b).
2. Kompletace svtla.- Vyberte sprvnou kombinaci sklennho stntka
a devn mon-tury. - Prothnte napjec kabel skrz sklenn stnidlo a
usate devnou monturu.- Pokud je sklo mrn vyoseno, opatrn s nm na
devn montue pootote, poppad pouijte silikonovou oku (obr. 2a),
kterou nalepte na vnj st devn montury (mezi sklo a devnou
mon-turu).- Elektrick kabely jednotlivch svtidel prothnte kovovm
balda-chnem a zafixujte zajiovacmi plastovmi oky. - Zite elektrick
propojen svtidla s elektroinstalac. - Pomoc imbusovch roubk a
imbusovho kle piroubujte bal-dachn kstropnmu drku (obr. 1).
1. Ke stropu piroubujte drk stropnho baldachnu (obr. 1). - S
ohledem na rzn typ i st materil strop doporuujeme mont konzultovat
s odbornkem. Vrobce svtidla neodpovd za nevhodn zvolen pracovn
postup i vady materilu, do kterho se nosn komponent instaluje.
3. Zapnte pslun jisti a ovte funknost svtidla.
280
170
2000
400x 60
-
2Uit materily
Sklo:Uit technologick postupy vychzej z nkolikasetlet tradice
esk rukodln sklsk vroby. Tento respekt kmaterilu a jeho tradin vrob
je pro firmu Brokis pznan. Ppadn nedo-konalosti skla jsou zapinny
zvolenmi technologickmi postupy a nemaj vliv na kvalitu a funknost
svtidel.
Devo: montura zdubu evropskho (QUERCUS SPP)Devo je prodn
materil, kter reaguje na zmny okolnho prosted zejmna vlhkosti a
teploty. Pi extrmn nzk relativn vlhkosti vzduchu (pod 30 %) dochz k
vysychn deva a nsledn tvorb trhlin. Proto doporuujeme udrovat
relativn vlhkost vzduchu mezi 40 - 60 % a teplotu od 15 do 25 C.itn
Svtidlo je mon oetovat bnmi isticmi prostedky. Nepouvejte
rozpoutdla a abrazivn istic prostedky (prky).
U kadho svtidla vetn jeho komponent je ped expedic dkladn
zkontrolovna funknost. Vrobce nenese odpovdnost za nesprvn zachzen
sprodukty.
Technick podpora: [email protected]
1a
2a 2b
M4 screws
M4 screws
canopy cover
cealing rack
Use this holes for the fixing rack onto the ceiling.
PC929_enPC929_cz.pdf
