PCB to gcode (from design to drillI. Eagle:1. Run Eagle2. Open
***.brd file3. Run eagle4-1.ulp4. Exit EagleII. Eagle2Pro:1. Run
Eagle2Pro2. Convert ***.txt file and save to ***.pcbIII.
Protel99SE1. Run Protel99SE2. Open ***.pcb file3. Click File >
New > Cam output > Choose NC Drill4. Right Click on NC Drill
output and click Generate CAM file5. Right click on CAM for.... and
export to a folder.6. Exit Protel99SEIV. PCB-ZXD1. Run PCB-ZXD2.
Open ***.txt file result from Protel99SE3. Set Drill
configuration4. Resulting a chinese folder5. Exit PCB-ZXDV.
Mach3Mill1. Run Mach3mill2. Open a file from chinese folder in
Notepad > select all and copy3. Edit Gcode in Mach3mill then
> paste4. Save as in diferent folder in txt format.5. Open
***.file by Load Gcode file6. Good luck!
