SOLIDWORKS DESIGN FOR MANUFACTURE AND ASSEMBLY DESIGN FOR
LIFTING MECHANISM WATER PRUIFICATION WITH SES
1. DESIGN FOR MANUFACTURE & ASSEMBLY 1.1. Part 1 Exploded
Features Introduction of Cylindrical Snap fits on Base 1.2. Part 2
Exploded Features Introduction of Single and Double Cantilever snap
fit on Sub-assembly
1.3. Part 3 Exploded Features Introduction of Cylindrical and
Cantilever Snap fits on Top
1.4. Part 4 Exploded Features Assembly of all sub-assemblies
2. DESIGN FOR LIFTING MECHANISM
2.1. Marketing Poster of Lifting Mechanism with estimated Market
Retail Price
2.2. Isometric Projection of Lifting Mechanism
2.3. Engineering Drawing of Bolted Part and Fixture 2.4.
Engineering Drawing of Frame and Lifting Platform 2.5. Engineering
Drawing of Link 1 and Link 2 2.6. Engineering Drawing of Power
Screw and Welded Part 3. WATER PURIFICATION WITH SES
3.1. Simulation of Load Distribution
3.2. Sequence of 5-step Installation
3.3. Engineering Drawing of Base and Fulflo Astra DE Filter 3.4.
Engineering Drawing of Multiport Valve and Trimline Bag Filter
