-
17KDL-40V4100/40V4150
KDL-40V4100/40V4150
1
2
LCD Panel
Balancer (ETC- Inverter MT) Board
Balancer (ETC- Inverter MT) Board
Inverter Board Cover
WARNING
NEVER REMOVE THE SCREWS SECURING THE PLASTIC STRIP HOLDING
THE LAMP SOCKETSDAMAGE TO THE
BACKLIGHT TUBES WILL
!
OCCUR!
1-9. BALANCER (ETC- INVERTER MT) BOARD REMOVAL
1 Remove 8 screws 2 Pull out the Board from the Lamp Socket
SHIELD REMOVALBALANCER (ETC-INVERTER) BOARD REMOVAL
WARNING
NEVER REMOVE THE SCREWS SECURING THE PLASTIC STRIP HOLDING
THE LAMP SOCKETSDAMAGE TO THE
BACKLIGHT TUBES WILL
Only remove the screws securing the inverter cover which may be
metal or plastic. The remaining plastic strip contains sockets for
the fluorescent backlights and should never be loosened. The
backlights will pop out of the sockets and/or break the backlight
requiring a LCD panel replacement.
REMOVE SCREWS SECURING
SHIELD
REMOVE CONNECTORS AND
PULL BOARD TO THE RIGHT
!
.
OCCUR!
BACKLIGHTEND VIEW
SOCKET
NOTE: The LVDS cable can only be installed one way. There is
colored tape on the cable to determine which side is attached to
the TCON and which side is attached to the BU Board. Refer to Wire
Dressing Illustration Installation Procedure on Page 33.
-
18KDL-40V4100/40V4150
KDL-40V4100/40V4150
1 Slide out Speaker (R) unit from Bezel2 Slide out Speaker (L)
unit from Bezel3 Remove 2 screws from Under Bar4 Disconnect 1
connector and Slide out H3E Board from Clear Panel5 Release hooks
and remove from Bezel6 Remove 1 screw and Release hooks from Clear
Panel7 Disconnect 1 connector and Slide out H4 Board from Light
Guide
1-10. SPEAKERS, UNDER BAR, H3E BOARD, H4 BOARD, AND LIGHT GUIDE
REMOVAL
Speaker Unit (L)
Speaker Unit (R)
Light Guide
Under Bar
H3E Board
H4 Board
Clear Panel
2
3
1
5
4
6
7
-
19
KDL-40V4100/40V4150
KDL-40V4100/40V4150
H Board/Speaker Harness
Apply harness to Panel TOP edge. To center Harness, positionRED
UL tape over center of panel. Use screw on panel asReference where
center of panel is. Apply Sheet core C overRed UL tape once harness
is centered. Apply Sheet Core Cover Black UL Tape on Harness
(guides).
Center of panel
1
3 2
WIRE DRESSING
LEGEND
SHEET CORE C (2-688-011-01)QTY=9
LCD TAPE (2-688-062-01)QTY=6
SLIDE CLAMP (2-650-770-11)QTY=6
-
20
KDL-40V4100/40V4150
KDL-40V4100/40V4150
LEGEND
SHEET CORE C (2-688-011-01)QTY=9
LCD TAPE (2-688-062-01)QTY=6
SLIDE CLAMP (2-650-770-11)QTY=6
Combination H Board/Speaker Harness
Apply Sheet Core C to Harness. Use BLACK UL TAPE on Harness as
guide where to apply Sheet Core C. Apply LCD Tape over speaker
wires. Use Black UL tape as guide where to apply tape. DO NOT apply
LCD tape over hole in speaker!
4
1
