Upload
others
View
6
Download
0
Embed Size (px)
Citation preview
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 1
U-Blox Receiver COM Port Setting
Dinesh ManandharCenter for Spatial Information Science
The University of Tokyo
Contact Information: [email protected]
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 2
Run Device ManagerYou will see SENSORS – u-blox GNSS Location SensorIf your receiver doesn’t work with this setting, update this driver
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 3
Click Mouse Right Button
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 4
Select this option
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 5
Select this option
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 6
Select this option
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 7
A new COM Port will be installed
Next, Remove usb cable and re-connect once again. You should see the same COM port
Dinesh Manandhar, CSIS, The University of Tokyo, [email protected] : 8
Run u-center and select COM Port. You will see the New COM port here. Select it.
It should work nowSee the COM Port and green light blinking here