Download doc - (2) Gb Over IP Interconnection Guideline

文档名称文档密级

Gb over IP interconnection guideline

1 The difference between static configuration and

dynamic configuration

There are only two differences between static configuration and dynamic

configuration:

(1) When configure the NSE, we need to configure the “server IP address” and “server UDP port

number” only for dynamic configuration.

(2) Remote NSVL need to be configured only for static configuration.

2 The network structure

3 configuration steps

(1) Configure NSE

BSC6000→Configure PCU Data → Configure NSE

2023-4-9 华为机密，未经许可不得扩散第 1页, 共 6页


(2) Configure the port IP

Board GFGUG → Configure Ethernet Port IP

(3) configure device IP

Board GFGUG → Configure Device IP


We don’t need to configure this part

when it is static configuration

Port IP


(4) Configure BSC router

Board GFGUG → Configure BSC Router

(4) configure local NSVL

Board GFGUG → Configure BSC Router


Device IP

The router to the logic IP of SGSN, it

should be a network section


(5) Configure remote NSVL

BSC6000→Configure PCU Data → Configure Remote NSVL

(6) activate the port

Board GFGUG → Configure Board Attributes


IP address: port IP

UDP port No.: any number

larger than 1024 is OK.

The same with local

NSVL of SGSN.


(7) configure PTPBVC

BSC6000→Configure PCU Data → Configure PTPBVC



4 Maintenance (MML)

（1）Ping IP

After you finish configuration, use MML to check the whether the

physical link between BSC and SGSN is OK.

（2）DSP REMOTENSVL

For dynamic configuration, this command is to check whether the

remote NSVL is ok.

（3）DSP GBIPROUTE

This command is to IP router which shows the status of NS.

（4）DSP SIGBVC和DSP PTPBVC

The normal status of SIGBVC and PTPBVC should be unblocked.
