Upload
mohammad-bahrami
View
561
Download
0
Embed Size (px)
Citation preview
Survey of Distributed Amplifier
ADVISER:DR.M.KAMAREISTUDENT: M.BAHRAMI
بررسی تقویت کننده توزیع شده
Contents:
INTRODUCTION
REVIEW
NEW PAPERS
REFERENCES
2
INTRODUCTIONShanon law
C=BWLog(1+SNR)
Distributed Amplifier
a method for wideband implemention
The key idea
divide and conquer
3
REVIEWBasic circuit :
The key idea :absorb parasitic capacitance
to artificial Transmission-lines overcome to substantiality tradeoff
Distributed amplifiers are attractive candidates
for UWB systemswide input-matching
wide gain bandwidth
excellent linearity
4
Figure 1 :basic DAFigure 2 :OFDM Receiver
REVIEW 5
Ali Medi MMIC COURSE NOTE ,2015
REVIEW 6
Ali Medi MMIC COURSE NOTE ,2015Figure 3 : Gain versus frequency for the DA
High-gain DA architectures 7
Cascaded
Matrix DAFigure 4 : Cascaded DA
Figure 5 : Matrix DA
Xin 09-06 (Low power-Wide band-High gain)
implemented in a standard 0.18 m CMOS technology.(In HG and LP)
Most of designs are based on the gaincell topology and do not
provide enough gain and bandwidth at very low power
consumption.
A major drawback of distributed amplifiers for UWB applications is
their large dc power consumption
Increasing Gain (n or gm)
8
Xin 09-06 Gain cell configurations used in CMOS distributed amplifiers
a) used at very long time, decent
gain, very large bandwidth
c) higher gm,mobility difference
9
Figure 6 : Gain cell configurations used in CMOS DAFigure 7 : Calculated gm of the proposed gain cell
and a CS gain cell stage.
Figure 8: Small-signal equivalent circuit
b) used to enhance reverse
isolation, does not provide significantly
high gm
d) proposed cascade
Xin 09-06
Peaking Inductance effect
10
=
Figure 9: frequency response of the gm of the proposed
gain cell for different values of inductance.
Xin 09-06Simulation Result :
11
Figure 11: S21 and S11 at low power state
Figure 12: S21 and S11
at high gain state
Figure 13: NF
Table 1:Performance summary
Figure 10: Microphotograph of the
low power distributed LNA (1.60×9𝑚𝑚2 )
Chien 07 (High-Gain)
implemented in a standard 0.18 m CMOS technology.
Conventional DA:
1)The gain in the DA is limited by the attenuation
2)The DAs exhibit an additive gain mechanism
In order to effectively improve the gain increment with the
number of cells, cascaded DAs have been proposed.
12
Chien 07
Cascaded DA :
13
Figure 14: Cascaded DA
Figure 15: Matrix DA
Matrix DA :low frequency Gain
haigh frequency Gain
loading effect at the interstage
artificial transmission line
Chien 07
Proposed DA : full advantage of themultiplicative gain mechanism
Advantages:gain grows exponentiallyonly one terminationcharacteristic impedance
14
Figure 16: Proposed DA
Chien 07Bandwidth Considerations:
the parasitic capacitance at the cascode node creates a
nondominant pole within the required bandwidth .
inductive shunt and series-peaking technique:
L1,L2,L3 are inserted to split the capacitances at the internal
15
Figure 17: Proposed DAFigure 18: Gain of DA
Chien 07
Stagger tuning technique:
down-scaling the interstage L3 from the input linetoward the output
16
Figure 19: the stagger-tuning technique.
Chien 07 Simulation Result :
17
Figure 20: Proposed DA
Chien 07 18
Table 2:Performance summary
Figure 21: Sparam of proposed DA
Moez 08 (Low-Noise)
implemented in a standard 0.13 m CMOS technology.
Used a technique for the design of ultra-wide-band low-noise amplifiers.
NOISE SOURCES IN CMOS Das
a)Transistors
b)Termination Resistor
c)Input Source Resistor
d)On-Chip T-L
19
Figure 22: Noise source in DA
Moez 08NOISE FIGURE CALCULATION :
A significant contributor to the DA’s noise
20
Figure 23: Noise contribution of
gate line terminating resistor
Passive termination
(dominant) Transistors
Resistive load
Moez 08
Proposed low noise DA
the terminating resistorreplaced with a resistive-inductivenetwork.
in low frequency Rg2
in high frequency Rg2+Rg1
intentional mismatch
21
Figure 24: CDA and Proposed DA
Moez 08
Simulation Result :
22
Figure 25: S11 and NF in CDA and LNDA
Figure 26: Noise Figure
Table 3:Performance summary
Lin 2011 (Gain Cell)
implemented in a standard 0.13 m CMOS technology.(LG,HG,LP)
using cascaded gain cell
Proposed two stage DA
23
Figure 27: Proposed gain cell
Figure 28: Proposed DA
Lin 2011
Formed by an inductively parallel-peaking
cascode-stage low Q and an inductively
series-peaking common-source stage
RL network termination
24
Figure 29: Effect inductive peaking
Figure 30: Effect termination on S11
Lin 2011
Simulation Result :
25
Figure 32:Proposed DA
Lin 2011 26
Figure 31:simulation results
Lin 2011Simulation Result :
27
Table 4:Performance summary
Mesgari 2014(Low-Noise)
implemented in a standard 0.13 m CMOS technology.
DA with a feed forward path is presented
1) reduce noise (-.6dB) effects
2)improves the amplifier gain (+2dB)
3) without increasing its power consumption
Resolve the low gain in past papers
cascaded multi-stage DA
matrix DA
cascaded single-stage DA
negative capacitance
28
Mesgari 2014 Resolve the noise issue in past papers
RL network termination
Trans-Conductance coefficients of different stage
Active termination
CDA and ATDA
29
Figure 33: a)CDA , b)ATDA
a)b)
Mesgari 2014ATDA:
matching condition
1) Reverse isolation.
2) Noise and signal polarity
3) Increases the amplifier gain
30
Figure 34: ATDA
Mesgari 2014
Simulation Result :
31
Figure 35: Noise figure Figure 36: SParam
Mesgari 2014
Simulation Result :
Pass band gain 16dB (+2dB)
S11 and S22 are less then -10dB
The average NF for 100MHZ to 12
GHZ is 1.8 dB(-.6 dB)
32
Figure 37: Sparam
Chen 2014
DC-8O GHz Distributed Amplifier
DA plays a critical building block in many system
applications
high data-rate communications
broadband radio transceivers
high-resolution imaging systems
40-nm CMOS digital process
based on the CDA with CSSDA gain cell
33
Chen 2014 High gain and output power
The number of cascade stage of CSSDA and CDA are 4 and
2
34
Figure 38: a)DA , b)4-stages CSSDA
b)
a)
Chen 2014
1) In order to minimize the chip size, the artificial transmission-
line sections of DA are implemented with microstrip-line
instead of coplanar-waveguide (CPW)
2) Not offer the metal-insulator-metal (MIM) capacitor, the
inter-digital architecture is used in the de-coupling capacitor.
In order to obtaining more bandwidth,the ground plane
under the de-coupling capacitor is used to reduce the
parasitic effect.
35
Chen 2014 Simulation Result :
36
Table 5:Performance summary
Figure 39: SParam
REFERENCES:
[1] D. M. Pozar, Microwave Engineering, 3rd ed. New York: Wiley, 2005, pp.
422–496, 632–641.
[2] Ali Hajimiri, “Distributed Integrated Circuits: An Alternative Approach to
High-Frequency Design,” IEEE communication Magazine, vol. 40,no. 2, pp. 168-173, Feb 2002
[3] Behzad Razavi, Design of Integrated Circuits for Optical communication
Systems , 2nd ed. McGraw-Hill, 2012.
[4] K. Moez and M. I. Elmasry, “A low-noise CMOS distributed amplifier for
ultra-wide-band applications,” IEEE Trans. Circuits Syst. II, Exp. Briefs, vol. 55,
no. 2, pp. 126–130, Feb. 2008.
[5] X. Guan and C. Nguyen, “Low-power-consumption and high-gain
CMOS distributed amplifiers using cascade of inductively coupled
common-source gain cells for UWB systems,” IEEE Trans. Microw. Theory
Tech., vol. 54, no. 8, pp. 3278–3283, Aug. 2006.
37
REFERENCES:
[6] Mesgari, B.; Saeedi, S.; Jannesari, A., "A wideband low noise distributed amplifier with active termination," Telecommunications (IST), 2014 7th International Symposium on , vol., no., pp.170,174, 9-11 Sept. 2014.
[7]Y. –S. Lin , J. –F. Chang and S. –S. Lu “Analysis and Design of CMOS Distributed Amplifier Using Inductively Peaking Cascaded Gain Cell for UWB Systems” , IEEE Trans. Microw. Theory Techn., vol. 59, no. 10, pp.2513 -2524 2011
[8] J.-C. Chien and L.-H. Lu, “40-Gb/s high-gain distributed amplifiers with cascaded gain stages in 0.18-nmCMOS,” IEEE J. Solid-State Circuits, vol. 42, no. 12, pp. 2715–2725, Dec. 2007.
[9] Po-Han Chen; Kuang-Sheng Yeh; Jui-Chih Kao; Huei Wang, "A high performance DC-80 GHz distributed amplifier in 40-nm CMOS digital process," Microwave Symposium (IMS), 2014 IEEE MTT-S International , vol., no., pp.1,3, 1-6 June 2014.
[10] Ali Medi MMIC COURSE NOTE ,2015
38
Thank You
39