View
24
Download
0
Category
Preview:
Citation preview
ALIMAK
Cable trolleyCable trolley
Mast tie
Mast section2'-4 1/2" sq x
4'-11 3/8"
Stru
ctur
e
Dooropening
24'-6
" M
axim
um a
bove
upp
erm
ost t
ie-in
(ove
rhan
g)*
15'-5
" M
inim
um a
bove
upp
erm
ost l
andi
ngor
top
tie (
Loca
l sta
ndar
ds m
ay a
pply
)
30'-0
" M
axim
um m
ast t
ie s
paci
ng*
15'-0
" M
inim
um m
ast t
ie s
paci
ng*
*Tie
spa
cing
may
var
y, s
ee M
anua
lor
con
tact
Mor
row
eng
inee
ring
Doo
r ope
ning
Enclosureextension kit
Hoist car
Cable guide
4'-11"12'-7 1/2"
6'-7
"
Base enclosure
Entrance level
4'-7
1/2
"
Entry ramp/dockby contractor
per ANSI A10.4
3'-6
"8'
-6 1
/2"
12'-0
"
14'-7
"
*Max
imum
ove
rhan
g m
ay v
ary,
see
Man
ual o
r con
tact
Mor
row
eng
inee
ring
Alimak FC 6200-12D Model FC 28/37 TD Dual Car Construction Hoist
MEC-MKT-137303/15/21
1
14'0-½" 14'-6"
Landing sillANSI A10.4 specifies a ½” (min.) to 2 ½” (max.)clearance between car and
landing sill
MEC-MKT-137303/15/21
2
S P E C I F I C A T I O N S
GENERAL
Meets the Requirements of ANSI A10.4
Max. load capacity ............................................6,200 lbs
Number of passengers ........................................30Car inside dimensions (approx.)
(per car)
(per side)
(per car)(per car)(per car)(per car)
(per car) ............................12'-2" x 4'-11" x 7'-3"
Side gate opening (if equipped) ............................6'-7" x 10'-6" Mast section length..............................................4'-11 3/8" Speed ................................................................Up to 157 fpm
Motors (VFD) .......................................................3 x 15 hp (11 kW)
Max. freestanding mast height 21
...........................
WEIGHTS
Base enclosure (without car) ....................................3,090 lbs
Hoist car (without motorpack) ..................................5,370 lbs
Base enclosure (with one car) ..................................6,922 lbs
Mast section (single rack) ......................................... 254 lbs
Mast section (double rack) ........................................ 341 lbs
Motorpack (3 x 15 hp) ...........................................1,965 lbs
ELECTRIC POWER
Power supply fuses
480 V phase–phase, 277 V each phase to ground with 120° phase shift between phases. 3-phase, 60 Hz power supply plus ground wire. Do not use Open-Delta supply.
................................................100 Amps Starting current .......................................................170 AmpsPower consumption ..................................................87 kVA
Max. standard lifting height ...............................490'
Max. untied mast overhang3
3
4
3
................................24'-6"30'-0"
Max. mast tie spacing ........................................30'-0"Minimum mast tie spacing ..................................15'-0"
¹ Maximum capacity of 6,200 lbs to a lifting height of 490'. Contact Morrow Equipment for specific capacities at greater lifting heights.² Requires use of an embedded foundation frame in lieu of mast anchor expansion bolts. See operation manual or contact Morrow engineering for specific information. Foundation anchorage provided by customer.³ Maximum untied mast overhang and mast tie spacing dimensions vary subject to installation conditions, manufacturer specifications, and regulatory compliance. See manufacturer data or contact Morrow Equipment for specific information. Greater lifting heights are available. Contact Morrow Equipment for specific information. Up to a lifting height of 200'. For heights greater a 125Amp service is required.
4
Alimak FC 6200−12D
5
5
Recommended