View
0
Download
0
Category
Preview:
Citation preview
OSCOP P DAKON 연결
1. DKONE PC 설정
① Parameterize PC 실행 (Password : OSCOP)
② Configuration - Device - Add 클릭 (Quality Recorder 선택)
③ Connection - Lan 선택하여 연결하고자 하는 Device의 IP주소를 입력한다.
④ Configuration - Output Device - Evaluation PCs - Add new evaluation PC클릭
⑤ Connect 클릭후 DAKON에 연결하고자 하는 PC(Client, Dakon, Evluation)의 IP주소를 입
력한다.
⑥ Parameterize Device 실행
⑦ Device 선택하여 OK 클릭 (새로 생성한 Device 선택)
⑧ 최초 접속시 Setting Download 받을것인지에서 Yes 선택하여 Download 받는다.
⑨ Transmit 실행
⑩ Configuration - Automatic mode - Sequential control 클릭
⑪ Device 선택하여 Auto polling Check한다.
⑫ Configuration - Automatic mode - Transfer Time 클릭
⑬ Start / End Time - 00:00 / 23:59 으로 설정한다.
2. Evaluation PC
① Server PC에서 Transmit-Automode 실행된 상태에서 아래 작업이 진행되어야 한다.
② Parameterize PC 실행 (Password : OSCOP)
③ Configuration - Dakon 클릭
④ Add 클릭
⑤ Name과Type은 DAKON선택
⑥ Connection - Lan선택후 접속하고자 하는 DKON PC의 IP 주소를 입력한다.
⑦ Device List 클릭하여 접속하고자 하는 Device를 선택하여 Adot클릭한다.
⑧ Parameterize Device 실행
⑨ Device 선택한후 Parameter - Load from DAKON 클릭
※ 위 절차완료후 Client PC, Evaluation PC에서는 DAKON을 통해서만 접속 및 고장 Data
Download가 가능하며, DAKON PC에서만 정정 수정이 가능하다.
Recommended