Dulu sy pernah Buat tutorial cara nak buka laptop compaq V3000 kali saya sediakan tutorial

bergambar cara nak buka laptop compaq CQ40 bagi pengguna CQ40 yang nak bukan dan service

laptop sendiri boleh la ikut tutorial ni

Peralatan yang diperlukan

1- skru driver mata bunga (yg kecik)

2- berus cat ape2 berus yg blh buang habukhuhu

LANGKAH ndashLANGKAH

Turn the computer upside down with the rear toward you

Remove the Phillips PM20times20 broadhead screw (1) from the optical drive bay the

Phillips PM25times50 screw (2) from the hard drive bay the four Phillips PM20times30 screws (3) from

the battery bay and the two Phillips PM25times100 screws (4) from the base enclosure rear corners

that secure the keyboard cover to the computer

Remove the Phillips PM25times30 screw (1) from the power button board

Lift the power button board (2) up and away from the keyboard cover

Remove the wireless antenna cable (1) from the hole in the system board and the routing channels

and clips built into the top cover

Disconnect the display panel cable (2) that runs along the left side

Remove the microphone cable (1) from the hole in the system board and the routing channels and

clips built into the top cover

Disconnect the microphone cable from the system board (2)

Remove the wireless antenna cable (1) from the hole in the system board and the routing channels

and clips built into the top cover

Disconnect the display panel cable (2) that runs along the left side

Remove the microphone cable (1) from the hole in the system board and the routing channels and

clips built into the top cover

Disconnect the microphone cable from the system board (2)

Step kat bawah ni tak perlu ikut bg yg nak servis FAN je kalau nak tukar LCD anda kene ikut step

bawah ni

If it is necessary to replace the display cable follow these steps

a Peel back the plastic (1) that covers the cable

b Remove the tape (2) that secures the cable to the display

c Unplug the cable (3) from the display

d Remove the cable from the display (4)

ok sambung blk terbalikkan laptop anda dan buka semua skru yg ada pada bahagian bawah spt

dlm gmbr

Disconnect the following cables from the system board

Bluetooth module cable (1)

TouchPad cable (2) with zero insertion force (ZIF) connector

Remove the top cover (3)

Remove the TouchPad button board (5) from the TouchPad bracket

tak perlu buka bg yg nak service FAN

Remove the Bluetooth module (5) from the top cover

Remove the modem module

Remove the audio board (4)

Lift the USB board (4) straight up to remove it from the computer

Disconnect the power connector cable

Remove the heat sink (gantikan thermal paste yang baru)

tanggalkan dan bersihkan FAN laptop anda