8/13/2019 3.Creo+Revolve

1/1

Creo 1.0 Parametric Reference page: Revolve

1. Select Revolve from top menu2. Click on required datum plane (e.g. RIGHT) or a plane surface of an existing solid3. Draw required shape (e.g. circle) which must be closed - use Sketch Validity Tools to check

4. Add a Geometry centreline (or a datum axis must have been created first) - the existing edge of a solid can also beused as axis

5. Click green tick6. Change the revolve angle (default is 360) by entering value or drag (white) handle and click green tick to apply7. Save the part

JM April 2012

Revolve type variable or symmetricSide 2 can be different

Solid shape

Change direction (other side of datum)

Revolve anglePreview Apply

Cancel

Revolve angle

Thin wall

Remove material(from solid)

Axis