Abhishek Mishra 4720 E Atherton Street • Long Beach, CA 90815 • abhishek19921993@gmail.com

Objective – Looking for a challenging position in electronic designing which can provide an avenue for growth. Education

California State University, Long Beach Fall 2014-Fall 2016Master of Science in Electrical Engineering, GPA: 3.33 Area of emphasis: Analog and Digital Design, Mixed Signal, VLSI

GITAM University, Visakhapatnam (India) June 2010-May 2014Bachelor of technology in Electronics and Instrumentation Engineering, GPA: 7.05/10

Engineering ProjectsMicroelectronics and Mixed Signal IC Design Fall 2014 and Summer 2015

Designed a 4 Bit Serial Input Parallel Output Shift Register using Microwind and DSCH. Schematic and Layout of a 4-bit charge-redistribution serial Digital to Analog Converter using Xilinx ISE Design Suite and Microwind. Schematic and Layout of a 4-bit flash Analog to Digital Converter using Xilinx ISE Design Suite and Microwind.

RF and Microwave Engineering Spring 2015

Calculated the input impedance of a transmission line as a function of frequency with an open and short load.

Built a 2-port network with a Micro strip line, calculated the Line Calculation to design and simulate the circuit for both open and short loads using Advanced Design System.

Microwave Amplifier – Designed a matching network to match 50 Ohm feed line to a load using a shunt open single stub using Advanced Design System.

VLSI Design Fall 2015 Designed a 10-bit by 10-bit multiplier using only half adders and full adders at gate level using Xilinx

tool “Vivado” and simulated it using Verilog. Designed a Boundary Scan cell with the help of Field Programmable Gate Array.

Master’s Project Fall 2015 to Fall 2016 Home automation using EEG signals – Extracted raw EEG brainwaves using NeuroSky

headset and controlled the appliances by programming an Arduino Uno board.Bachelor’s Project Summer 2013 to Spring 2014

Solar Tracking using Keil Microvision and a Microcontroller – Worked on a Micro-controller AT89C51 to automatically orient a payload using LDR using Keil Microvision IDE.

Work ExperienceHindustan Petroleum Corporation Ltd, Visakhapatnam, India April-July -2012

Assistant Intern: Analyzed different field instruments which were used to maintain pressure, temperature, and flow within a specified limit. Learned about the central control system.

Computer Software Skills

Microwind (Transistor Layout tool) DSCH (Gate Layout tool) Xilinx ISE Design SuiteCadence OrCAD PCB Designer Verilog Xilinx Vivado Design SuiteAdvanced Design System LabVIEW Python

Achievements and extra-curricular Secured 2nd position in Paper presentation conducted by BITS PILANI, Hyderabad Campus. Won the Green Engineer event organized by IEEE in GITAM University. Participated in Robowars titled “Rage of Titans” in BITS Pilani, Hyderabad Campus.