Cc422 Electrico

8/16/2019 Cc422 Electrico

1/34

DYNAPAC

CC222/422/52

WORKSHOP MAN

ELECTRIC CIRCUDIAGRAM

W1035EN4


2/34


3/34

Vibratory and Combination Rollers CC 222/222C and CC 232/232C CC422/522

Work Shop Manual, Electric Circuit Dia W1035EN4

This instruction apply from PIN (S/N)CC 222: *61710222*, CC 222C: *6181022CC 232: *61910232*, CC 232C: *6201023CC 422: *62510424* , CC 522: *6291052


4/34


5/34

Electric Circuit

Diagrams

Contents

Safety Regulations ..............................................................................

2 Starter & BrakesMain 1, Master & Ignition Switches off ........................................Main 2, Master & Ignition Switches off ........................................Main 1, Starter Motor Running.....................................................Main 2, Starter Motor Running.....................................................Main 1, Machine Moving ...............................................................Main 2, Machine Moving ...............................................................

3 Offset Steering Joystick Steering, Right Turn, Pivot ............................................. Joystick Steering, Left Turn, Pivot ............................................... Joystick Steering, Right Turn, Articulated Joint .......................... Joystick Steering, Left Turn, Articulated Joint ............................

4 Vibration SystemHigh Amplitude, Low Frequency, Manual Mode......................High Amplitude, Low Frequency, AVC Mode ..........................Low Amplitude, High Frequency, Manual Mode......................Low Amplitude, High Frequency, AVC Mode ..........................High Amplitude, Low Frequency, Front drum only, Manual M

5 Sprinkler SystemManual Mode, Standard Machine ................................................Manual Mode, Combi Machine ....................................................Automatic Mode, Standard Machine ...........................................Automatic Mode, Combi Machine .............................................Manual Mode, Sprinkler timer, Standard Machine ......................


6/34

Electri

D

Safety Regulations

General advice

· Make yourself familiar with the equipment of the machine.

· Only operate the machine if your are completely familiar with thecontrol elements as well as the functioning of the machine.

· Use your safety equipment like helmet, safety shoes and hearing p· Make yourself familiar with your working field.· Only operate the machine for its intended purpose.

Please observe the guidelines of the machinmanufacturer and safety manual, A 281.

Before starting


7/34

Electric Circuit

Diagrams

Start

• When starting, all operating levers must be in ”neutral position

• Only start the machine from the driver’s seat.• Check the indicating instruments after start to ensure that all fu• Do not leave the machine unattended when the engine is runnin• When starting with battery connection cables, connect plus to pto minus.• Disconnect the earth (negative) first. Connect it last.

Warning

Exhaust fumes is dangerous. Ensure sufficient fresh air wh

closed rooms!

Hydraulic equipment

1. Hydraulic equipment is under high pressure.

Fluids (fuel, hydraulic oil) which escape under high pressu

the skin and cause serious injury.Therefore immediately consult a doctor if such injury occinfection may otherwised be caused.

2. When searching for leaks use appropriate means because of the3. Before working on hydraulic equipment, de pressurize to zero

working arms of the machine.4. When working on hydraulic equipment, switch of the engine an

Safety Re


8/34

CC222/422/522 Electric circuit diagrams W-1035- 4 EN 6


9/34

7 CC222/422/522 Electric circuit diagrams W-1035- 4 EN


10/34



11/34


12/34



13/34


14/34



15/34



16/34



17/34



18/34



19/34


20/34



21/34


22/34



23/34


24/34



25/34



26/34



27/34



28/34



29/34



30/34



31/34



32/34



33/34



34/34


Documents

Cc422 Electrico