1

4 5

2

3

QUICK START

HOLY STONE

① Fully Charged battery for drone, 4 new ”AA” for transmitter.

内容使用字体：Eras Light ITC 封面字体：Expansiva

② Power on the transmitter and then the drone.

Power

比例 1.000

HS110D

HS200D

TAIL

HEAD

UP

DOWN

Ascend

⑥ Turning

⑦ Direction

Forward

Backward

Move Left Move Right

Descend

Turn Left Turn Right

⑤ Ascend and Descend. ⑧ Emergency Stop.

Phone Adapter(Not Included): 5V/1A or 5V/2A

Indicator

Email Support :

USA@holystone.com (America)CA@holystone.com (Canada)EU@holystone.com (Europe)

HotLine Support : +1(855)888-6699

ENGINE START/ LANDING

(Pic1) (Pic2) (Pic3)

③ Place the drone on a level surface, make sure the tail of drone faces the pilot. Then push the throttle level up then down to pair the drone and transmitter.

④ Press “Engine Start”(Pic1), propellers rotate at low speed, push the left stick up (Slowly) to take off (Pic2), press “Engine Landing” button (Pic1) again to land the drone,or push the right stick down(Pic3) until drone touchs the ground, hold a few seconds to stop the motors.

Only stop motors mid-flight in emergency situations when doing so can reduce the risk of damage or injury.

Press the UP LEFT(Photo Function) and UP RIGHT(Flip Function) button at the same time, the motors will stop immediately.

⑨ Red indicator is on when charging, and will be off when fully charged.Charging time depond on the phone Adapter’s rated power, it takes about1-1.5 Hour to fully charge the battery.

For more details, please read the instruction for use. And do not hesitate to contact us if you need any support.

If you’re satisfied with our product orservice, please leave us a feedback and review on our page.