Copyright © 2011 Robin Quilts, etc. All rights reserved.

Fabric Card Wallet

By Robin Gallagher, www.robinquiltsetc.com

1 piece of fabric - 4 1/2” x 17”

1 piece of Velcro (I use Fabric Fusion by Velcro)

Lay fabric on ironing board right side face down.

From end 1: Fold up 1/2” - press

Fold up 5/8” - press

Fold up 2” - press

From end 2: Fold up 1/2” - press

Fold up 5/8” - press

Turn fabric over so that the right side of fabric is facing up

From end 1: Fold up 2” - press

From end 2: Fold up 1 1/2” - press

Now fold right sides together matching pressed ends - piece should measure approxi-

mately 4 1/2” x 4 1/2”. Sew down both sides (raw edge sides, not folded ends) using a

1/4” seam. Backstitch at each end.

Turn right side out and then turn the short end over to

create the card pocket.

Center the rough side of the Velcro piece on the inside of the flap about 1/8” from the top

fold. Iron in place. Attach the soft side of the Velcro piece to the rough side Velcro piece

and close the flap. This give you the placement for the soft sided Velcro piece. Iron in

place using high heat and steam.

Your card holder is now complete and has two pockets to hold business cards, credit

cards or loyalty cards.

Enjoy,