Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 1 of 10
FFUSB Installation procedure for FieldMate™
FieldMate™用の FFUSB
のインストール手順
FFUSB 和 FieldMate™
使用安装流程
+ = C
Get Started
1 Complete FieldMate installation process.
FieldMate のインストールをします。
横河 FieldMate
软件安装过程
2
Insert installation CD in CDROM drive and wait until the below screens show up automatically.
インストール CD を挿入すると自動的に下記の画面が表示されます。
先在光驱中放入安装光盘等待直到自动出现以下的画面
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 2 of 10
3
ATTENTION CommDTM is NOT needed when using FFUSB with FieldMate version R2.03 and later!
注意:FieldMate の上でFFUSB を使用する場合はCommDTM は「不要」です!
注意: 在使用 FieldMate 和FFUSB 时不需要 CommDTM
4 Installation of Yokogawa Interface (FFH1YIF) driver.
Yokogawa Interface (FFH1YIF)ドライバのインストール手順
安装 Yokogawa 接口(FFH1YIF)驱动的流程
(1)
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 3 of 10
(2)
(3)
6...
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 4 of 10
(4)
(5)
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 5 of 10
(7)
(6)
6...
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 6 of 10
That’s all!! 以上!!! 如上确定
5
After successful installation of FFH1YIF driver the Control Panel’s “Programs and Features” looks like the screen below.
FFH1YIF ドライバが正常にインストールされると、コントロールパネルの“プログラムと機能”は下図のようになります。
在成功安装 FFH1YIF 驱动之后, 控制面板的’’程序和功能’’ 窗口如下图所示
6
When you connect FFUSB to the PC for the first time, the sequence shown below will occur. Please be a little patient.
初めて FFUSB をパソコンに刺した時は下記の様な画面がでます。ドライバのインストールが終了には多少時間が掛かります。
如果您第一次将 FFUSB 连接到 PC, 会出现以下的画面, 请耐心等待
(8)
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 7 of 10
7
After normal driver installation you shall see the below screens from the Device Manager.
正常なドライバインストール後にデバイスマネージャの画面は下記の様になります。
在驱动正常安装后, 可以在设备管理界面见到如下画面
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 8 of 10
8 You can confirm installation of FFUSB in FieldMate…
FieldMate 上の FFusb の設定は下図の通りに確認可能。。。
可以确定 FFusb 在 FieldMate
软件中安装
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 9 of 10
9 Adjusting FF-H1 network parameters is possible from FieldMate
FieldMate から FF-H1 の通信設定が可能です。
可以在 Fieldmate 软件中设置FF-H1 网络参数
Foundation Fieldbus H1
Application Note
Version 2.0, June 1st, 2011 Page 10 of 10