Embed Size (px)
Citation preview
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 1/16
HAMMER MAZE
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 2/16
CEILING BOLT
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 3/16
FLOOR BOLT
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 4/16
POSTS: THESE ARE
TWO SIZES OF
SQUARE METALPOSTS ONE SLIDING
IN OTHER. THERE IS A
CLIP THROUGH THIS
THAT HOLDS THE
POST AT A CERTAIN
HEIGHT. THE BOTTOM
AND TOP ARE PLACED
OVER THE BOLTS IN
FLOOR AND CEILING.THE TWO POSTS ARE
SLID APART AND
LOCKED INTO PLACE
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 5/16
LATCHES
HOLDING
PANELS
IN PLACE
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 6/16
SLIDING
LATCH
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 7/16
PANELS
FASTENED TO
POSTS
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 8/16
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 9/16
PANEL TO SIMULATE WALL STUDS
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 10/16PROP LAID ON FLOOR TO SIMULATE RAFTERS
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 11/16
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 12/16
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 13/16
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 14/16
RAMP TO
SECOND FLOOR
SO YOU WILLHAVE TO GET
LADDER TO
CLIMB OR USE
OTHERMETHODS
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 15/16
8/14/2019 HAMMER MAZE 2003
http://slidepdf.com/reader/full/hammer-maze-2003 16/16
USE ONE METAL POST AND THREADED POST THAT SLIDES INTO. THIS
WILL BE SCREWED UP INTO A 2X4 ACROSS CEILING AND BOLTED
INTO PLACE. THE METAL POST WILL BE PLACED OVER A BOLT
ANCORED INTO THE FLOOR. WE WILL THEN MAKE PANELS AND HOLDIN PLACE LIKE HAMMER
METHOD THAT
WE WILL BE
USING IN OAK
HARBOR
