Upload
jitendra-jangid
View
136
Download
7
Embed Size (px)
DESCRIPTION
WORKING OF BASIC MODULE FOR EMBEDDED SYSTEM LIKE LCD, IR TX RX, SWITCH MATRIX,MOTOR DRIVER ETC
Citation preview
Working IR Tx and Rx Module
Working Motor driver module
Power supply for Microcontroller
Oscillator for Microcontroller
Reset circuitry for Microcontroller
Matrix Key Board 4x4
LCD in 4 Bit mode
FROM:JJ/2009/PART2
Application of IR Tx and Rx Module•obstacle sensing, •color detection, •fire detection, •line sensing,
FROM:JJ/2009/PART2
How does DC Motor work ???
Motor driver is basically a current amplifier which takes a low-current signal from the microcontroller and gives out a proportionally higher current signal which can control and drive a motor. >Output current up to 1.2A>Supply voltage can be as large as 36 Volts>over temperature protection" built into the IC.>This flyback diode helps protect the driver IC from voltage spikes that occur when the motor coil is turned on and off>The logical low in the IC is set to 1.5V.> high frequency applications upto 5KHz
FROM:JJ/2009/PART2
Require more current then the microcontroller pin can typically generate
Transistor as a current amplifier to provide required current to drive the motor
FROM:JJ/2009/PART2
•Turning on Switches A and D makes the motor rotate clockwise•Turning on Switches B and C makes the motor rotate anti-clockwise•Turning on Switches A and B will stop the motor (Brakes)•Turning off all the switches gives the motor a free wheel drive•Lastly turning on A & C at the same time or B & D at the same time shorts your entire circuit. So, do not attempt this.
FROM:JJ/2009/PART2
High ~+5V, Low ~0V,
>Pin2, Pin7, Pin10 and Pin15 are logic input pins. These are control pins which should be connected to microcontroller pins.
>Pin2 and Pin7 control the first motor (left); Pin10 and Pin15 control the second motor(right).
FROM:JJ/2009/PART2
Positive fee backPhase shift :Capacitive element =180 degreeInverting amplifier =180 degreeTotal =360 degree
FROM:JJ/2009/PART2