28
Мэдлэг дүгнэх хэлбэр Багшийн 70 оноо Семинарын ирц идэвхи - 20 оноо - Оюутан хичээлийн таслалтгүй - Семинар бүр дээрх дасгалуудыг 80%-аас дээш гүйцэтгэлтэй шалгуулсан тохиолдолд Бие даалтын ажил – 20 оноо Оюутан бие даалтын ажлуудыг заасан хугацаанд чанартай, бүрэн гүйцэтгэж, амжилттай хамгаалсан тохиолдолд Явцын сорил – 30 оноо Эхний ба сүүлчийн сорилын 100%-д зөв хариулсан тохиолдолд Улирлын шалгалт 30 оноо Шалгалтын асуулт ба сорилын 100%-д бүрэн гүйцэд үнэн зөв хариулт өгсөн тохиолдолд

Lecture 01

  • Upload
    -

  • View
    98

  • Download
    5

Embed Size (px)

Citation preview

Page 1: Lecture 01

Мэдлэг дүгнэх хэлбэр

Багшийн 70 оноо

Семинарын ирц идэвхи - 20 оноо

- Оюутан хичээлийн таслалтгүй

- Семинар бүр дээрх дасгалуудыг 80%-аас дээш гүйцэтгэлтэй

шалгуулсан тохиолдолд

Бие даалтын ажил – 20 оноо

Оюутан бие даалтын ажлуудыг заасан хугацаанд чанартай,

бүрэн гүйцэтгэж, амжилттай хамгаалсан тохиолдолд

Явцын сорил – 30 оноо

Эхний ба сүүлчийн сорилын 100%-д зөв хариулсан тохиолдолд

Улирлын шалгалт 30 оноо

Шалгалтын асуулт ба сорилын 100%-д бүрэн гүйцэд үнэн зөв

хариулт өгсөн тохиолдолд

Page 2: Lecture 01

Өгөгдлийн холбооны энгийн загвар

Source

ReceiverDestination

Transmitter

Communication System

Page 3: Lecture 01

• Source : Where the data originated (рс, төгсгөлийн төхөөрөмж, холбооны төхөөрөмж г.м)

• Transmitter : Converts data into a suitable form for transmission through the medium

• Communication System : Medium through which signal is sent

• Receiver : Which receives the signal and converts it into data or message

• Destination : Where the data is sent (рс, төгсгөлийн төхөөрөмж, холбооны төхөөрөмж г.м)

Өгөгдлийн холбооны энгийн загвар

Page 4: Lecture 01

Өгөгдлийн холбооны энгийн загвар

Source

ReceiverDestination

Transmitter

Communication System

d(t)

• d(t) : Data or Message is the information to be communicated

s(t)

• s(t) : Signal is that can be transmitted through a medium

Page 5: Lecture 01

• Өгөгдөл ба Өгөгдлийн төрөл

• Аналог ба Тоон өгөгдөл

• Дохио ба Дохионы төрөл

• Аналог ба Тоон дохио

• Үелсэн дохионы характеристик

• Хугацаа болон Давтамж

• Дохионы Спектр, Зурвасын өргөн

• Тархалтын хугацаа, Долгионы урт

Өгөгдөл ба Дохио

Page 6: Lecture 01

• Дамжууллын гэмтэл

• Унтралт ( dB )

• Дамжуулах орчны зурвасын өргөн

• Гажуудал

• Өгөгдлийн хурд

• Nyquist Bit Rate

• Bit Rate and Baud Rate

• Шуугиан

• Shannon Capacity in Noisy Channel

Дамжууллын гэмтэл ба Сувгийн багтаамж

Page 7: Lecture 01

Дамжуулах орчин

– Radio wave

– Microwave

– Infrared

Page 8: Lecture 01

Өгөгдөл Дохио Арга

Тоон Тоон Кодлол

Аналог Тоон Кодлол

Тоон Аналог Модуляц

Аналог Аналог Модуляц

Өгөгдлийг дохионд хувиргах

Page 9: Lecture 01

Digital data to Digital signal

NRZ-Level

NRZ-Invert

Page 10: Lecture 01

• Үндсэн 2 арга:

–Pulse code modulation

–Delta modulation

• PCM, DM харьцуулалт

Analog data to Digital signal

Page 11: Lecture 01

• Модуляцын аргууд:

– Агуургийн модуляц

– Давтамжийн модуляц

– Фазын модуляц

Analog data to Analog signal

Page 12: Lecture 01

Digital data to Analog signal

Page 13: Lecture 01

• Нягтруулга гэж юу вэ?

• Давтамжийн хуваалттай нягтруулга

• Долгионы хуваалттай нягтруулга

• Хугацааны хуваалттай нягтруулга:

– Синхрон

– Асинхрон

Нягтруулга

Page 14: Lecture 01

• Telephone system

– Analog Services

– Digital Services

• DSL technology: ADSL, SDSL, HDSL and VDSL

• Cable Modem

– Hybrid Fiber-Coaxial (HFC) Network

• SONET

Multiplexing Applications

Page 15: Lecture 01

Өгөгдлийн холбооны энгийн загвар

Source

ReceiverDestination

Transmitter

Communication System

d(t)

• s’(t) : Signal received through the medium

s(t)

s’(t)

Page 16: Lecture 01

• Interface

• Modes of communication– Parallel and Serial

– Simplex, Half –duplex, Full-duplex

– Asynchronous, Synchronous

• DTE and DCE interface– RS232

– Null Modem

– X.21

Interfacing

Page 17: Lecture 01

Өгөгдлийн холбооны энгийн загвар

Source

ReceiverDestination

Transmitter

Communication System

d(t)

• d’(t) : Data received at the destination and end

s(t)

s’(t)d’(t)

Page 18: Lecture 01

• Types of error– Single bit error

– Burst bit error

• Error detection techniques– Parity check

– Two dimensional parity check

– Checksum

– Cyclic redundancy check

• Error correcting codes – Hamming code

Error Detection and Correction

Page 19: Lecture 01

– Flow control techniques

• Stop-and-wait flow control

• Sliding-window flow control

– Backward error correction techniques

• Stop-and-wait ARQ

• Go-back-N ARQ

• Selective-repeat ARQ

Flow and Error Control

Page 20: Lecture 01

– Components of data link control

• Frame synchronization

• Flow control

• Error control

• Link management (start session, continues, terminal session)

– High-Level Data Link Control (HDLC)

• Types of stations

• Data transfer modes

• Frame format

Data Link Control

Page 21: Lecture 01

– Issues involved in WAN

• Switching techniques

• Routing

• Congestion Control

• Medium Access Control

– Frame Relay, X.25 and ATM

– Cellular Telephone system

– Satellite Communication

Data Communication through a WAN

Page 22: Lecture 01

– Switched Communication Network

– Circuit Switching fundamentals

• Advantages and Disadvantages

– Switching Concepts

• Space division switching

• Time division switching

– Message switching and Packet switching

• Virtual circuit and datagram approaches

Switching Techniques

Page 23: Lecture 01

– Issues involved in LAN

– Who, What, When?

• Addressing

• Error detection

• Transmission Media

• Topology

• Medium Access Control

– High speed LANs (FDDI, Fast Ethernet, Gigabit Ethernet)

– Wireless LANs (IEEE802.11, Bluetooth)

Data Communication through a LAN

Page 24: Lecture 01

The basic objective is to connect individual heterogeneous networks, both LAN and WAN, distributed across the world using suitable hardware and software in such a way that it gives the user the illusion of a single network. The single virtual network is widely known as internet, which is a network of networks.

Hardware : Router

Software : TCP/IP

The Internet

Page 25: Lecture 01

– Segmentation and Reassembly

– Encapsulation

– Connection Control

– Ordered Delivery

– Addressing

– Routing, Routing Protocol

– TCP, UDP

– Data Compression

– Data Encryption

– Transmission Services

Data Communication through Internet

Page 26: Lecture 01

– Why layered Approach?

– What is Layered Approach

– Basic Principles of Layered Approach

– Layers and Interface

– Entity and Protocols

– ISO’s OSI Reference Model

– Functions of different Layers of OSI Model

Layered Architecture

Page 27: Lecture 01

– Introduction and course outline

– Layered Architecture

– Data and Signal

– Transmission Impairments and Channel Capacity

– Guided and Unguided Transmission Media

– Transmission of Digital Signal

– Transmission of Analog Signal

– Multiplexing

– Telephone system and DSL technology

– Cable MODEM and SONET

Summary

Page 28: Lecture 01

– Interfacing to the Media

– Error Detection and Correction

– Flow and Error Control

– Data Link Control

– Switching Techniques : Circuit Switching

– Switching Techniques : Packet Switching

– IP addressing

– Routing, Routing Protocols

– TCP and UDP

– Application layer Protocols

Summary