Manual Gratis Chery Tig Go

Embed Size (px)

DESCRIPTION

Manual de reparación para Chery Tiggo

Citation preview

  • El siguiente Manual del Chery Tiggo es una MUESTRA GRATIS de los Manuales que puedes

    adquirir en la siguiente direccin:

    http://www.autodaewoospark.com/manuales-chery-tiggo-servicio-usuario.php

    Atentamente,

    Jorge E. Penagos P. http://www.autodaewoospark.com

  • Instrument Panel FeaturesLHD Instrument Panel Features

    1 - Air Outlet 5 - Radio 9 - Hazard Warning Flasher Switch 13 - Front Ashtray 17 - Hood Release Lever2 - Steering Wheel 6 - Passenger Side Airbag 10 - Cigarette Lighter 14 - Cruise Control Switch 18 - Headlight LevelingSwitch3 - Instrument Cluster 7 - Glove Box 11 - RH Heated Seat Switch 15 - Remote Audio SystemControls 19 - Rear Fog Light Switch4 - Driver Side Airbag 8 - Climate Control Panel 12 - LH Heated Seat Switch 16 - Dimmer Control Switch 20 - Front Fog Light Switch

    78 YOUR INSTRUMENT PANEL

    Chery Automobile Co., Ltd.

  • Instrument Cluster

    80 YOUR INSTRUMENT PANEL

    Chery Automobile Co., Ltd.

  • Hazard Warning FlasherThe hazard switch is located

    on the instrument panel,

    above the climate control

    panel. Depress the switch to

    activate both cluster indicators and all

    front and rear directional signals. De-

    press the switch again to turn the Haz-

    ard Warning Flashers off. This is an

    emergency warning system and it

    should only be used for emergencies.

    Use it when your vehicle is disabled or

    creating a safety hazard for other mo-

    torists.

    The hazard warning flashers will con-

    tinue to operate even though the igni-

    tion switch is on the LOCK position.

    NOTE: With extended use, the hazardwarning flashers may drain the battery.

    Jacking and Tire ChangingJack LocationThe jack is stowed under the load

    floor in the cargo area.

    NOTE: The maximum working load ofthe jack is 800 kg.Spare Tire LocationThe spare tire is stowed on the back

    door.

    Spare Tire Removal

    Release the spare tire cover clasp.

    Remove the spare tire cover.

    Jack Storage Location

    Spare Tire Location

    Releasing The Spare Tire Cover Clasp

    98 IN CASE OF AN EMERGENCY

    Chery Automobile Co., Ltd.

  • Jack Engagement Locations

    100 IN CASE OF AN EMERGENCY

    Chery Automobile Co., Ltd.

  • A blown fuse can be identified by the

    melted fuse wire.

    Fuse Color AmperageAuburn 5 ABrown 7.5 ARed 10 ABlue 15 A

    Yellow 20 AGreen 30 A

    Fuse Color AmperagePink 40 A

    Yellow 60 A

    Towing A Disabled Vehicle

    NOTE: Your vehicle is equipped withtow hooks at both the front and rear.

    CAUTION!Observe the following guidelines when

    towing the vehicle:

    Tow the vehicle slowly and smoothly

    to avoid damage.

    If the vehicle needs to be steered

    while being towed, the ignition

    switch must be in the ON position,

    not in the LOCK or ACC position.

    Power brake and power steering as-

    sist is not unavailable when the en-

    gine is off, the required operational

    force is increased significantly.

    (Continued)

    CAUTION! (Continued) Do not attempt to tow this vehicle

    from the front with sling type tow-

    ing equipment. Damage to the front

    fascia will occur.

    Removing and InstallingVehicle BatteryThe following steps must be taken

    when removing and installing the bat-

    tery:

    Turn the ignition switch and all elec-

    trical devices off.

    Remove the negative (-) battery

    cable.

    104 IN CASE OF AN EMERGENCY

    Chery Automobile Co., Ltd.

  • Proper Maintenance Of Your VehicleEngine Compartment - 1.6L / 1.8L / 2.0L

    1 - Power Steering Fluid Reservoir 6 - Power Fuse Box2 - Engine Oil Fill 7 - Engine Oil Dipstick3 - Brake Fluid Reservoir 8 - Cooling System Pressure Cap4 - Air Cleaner Filter 9 - Washer Fluid Bottle5 - Battery 10 - Engine Coolant Reservoir

    112 PROPER MAINTENANCE OF YOUR VEHICLE

    Chery Automobile Co., Ltd.

  • Engine Compartment - 2.4L

    1 - Power Steering Fluid Reservoir 6 - Battery2 - Engine Oil Fill 7 - Power Fuse Box3 - Engine Oil Dipstick 8 - Cooling System Pressure Cap4 - Brake Fluid Reservoir 9 - Washer Fluid Bottle5 - Air Cleaner Filter 10 - Engine Coolant Reservoir

    PROPER MAINTENANCE OF YOUR VEHICLE 113

    Chery Automobile Co., Ltd.

  • Service Manual for CheryTiggo(T11) Engine Section

    2

    Chapter 1 Overview Engine used in Chery Tiggo car is MITSUBISHI 4G64 (2.4L) and 4G63 (2.0L)

    model engine, which adapt single-overhead-camshaft, 4-cylinder 16-valve and multi-point sequential injection.

    I. Technical Data

    1. Engine Mode Number Indication

    Multi-point sequential injection 44 valve structure Single-overhead-camshaft

    Design serial number Product serial Gasoline engine 44 cylinder structure

    2.Engine Number Position

    Engine No.

  • Service Manual for CheryTiggo(T11)Engine Section

    12

    Chapter 2 Engine Structure

    Features

    1.Cylinder Cover Structure

    Features

    Cam bearing hole

    Spark plug pipe

    Inlet air duct

    2.Cylinder Cushion Structure

    3.Spark Plug Position

    Exhaust air duct

    Spark plug

    Inlet air duct

    Piston

    Cylinder cover is made of horniness

    aluminium alloy, which is firstly

    low-pressure-molten and then

    machining.

    Four-valve structure is applied and

    its advantage is increasing

    emission channel area and

    decreasing valve movement inertia.

    Agile fiberboard structure is

    applied. Many 1.5mm-diameter

    through holes are pressed in the

    steel board and fiber liquid mixture

    is filtered through steel board. And

    then sealant is sprayed on both

    sides of agile broad and the

    important part is additionally

    sprayed with seal thread.

    Spark plug is located in the center

    of chamber, which may let flame

    reach each chamber corner at almost

    the same time.

  • Service Manual for CheryTiggo(T11) Engine Section

    23

    Chapter 3 Valve gear

    I. Timing belt

    Disassembling steps

    1. front upper cap of timing belt

    2. front lower cap of timing belt

    3. power steering bracket

    4. crankshaft position sensor

    5. timing belt

    6. tensioning gear

    7. tensioner arm

    8. automatic tensioner

    9. idler

    10. oil pump pulley

    11. crankshaft screw bolt

    12.crankshaft

    timing pulley

    13.flange

    14.tensioner B

    15.timing belt B

    16. pulley of upper balance shaft

    17.bushing

    18.crankshaft

    timing pulley B

    19.right bracket component of engine

    20.screw bolt of camshaft pulley

    21.camshaft timing pulley

    Disassembling illustration

    8.8N.m

    8.8N.m

  • T11 Service Manual Transmission

    92

    Section Technical Data and Precautions

    1. Schematic Diagram

    1. Idler Assembly

    2. Pinion Gear, 4th

    Gear

    3. 3rd

    -4th

    Gear Synchronizer

    4. Pinion Gear, 3rd

    Gear

    5. Transmission Housing

    6. Clutch Box

    7. Release Bearing Saddle

    8. Input Shaft

    9. Output Shaft

    10. Differential Assembly

    11. Driven Gear of 1st Gear

    12. 1st-2

    nd Gear Synchronizer

    13. Driven Gear, 2nd

    Gear

    14. Driven Gear, 5th

    Gear

    15. Synchronizer of 5th

    -Gear and Reserve Gear

    16. Gear, Reverse Gear

    Schematic Diagram

  • T11 Service Manual Transmission

    118

    Section Clutch Box

    1. Clutch box

    2. Oil seal-input shaft

    3. Bearing-gear shifting mechanism

    4. Output shaft front bearing

    5. Oil seal-differential

    6. Front/rear bearing of differential

    7. Buttonhead-seat release fork

    8. Release bearing race

    9. Bolt GB5787 M612 10. Speedometer banking cover

    11. Pin GB119 A1020 12. Magnetic assembly

    13. Bush-gear shifting mechanism

  • T11 Service Manual Chassis System

    20

    Installation of Parking Brakes

    1. Replacement of Parking Brake Shoes

    1) Removal

    a. Remove the tire.

    b. Remove brake caliper, and refer to the section of "Disc brake" to replace the bracket of brake

    caliper.

    c. Refer to the replacement of brake disc to remove rear brake disc.

    d. Remove the rear wheel hub units.

    Remark: properly align the four holes in the

    brake hub units to the corresponding fixing

    bolts of brake elements.

    e. Remove the actuator of parking brake.

    f. Remove the brake shoes.

  • T11 Service Manual Chassis System

    40

    Front left wheel sensor

    Battery

    Combination Instrument

    Brake Indication Lamp

    Ignition Switch

    Diagnostic Interface

    Brake Switch

    Front right wheel sensor

    Rear left wheel sensor

    Rear right wheel sensor

  • Chery T11 Service Manual Body and Accessories

    -28-

    3) Unplug the high/low beam headlamp.

    4) Remove the three fixing bolts of headlamp

    assembly.

    5) Remove the headlamp assembly carefully.

    6) Install in the reversed sequence.

    Torque:

    Headlamp fixing 61Nm

    PART No.: T11-3772025 (3 pcs)

    4. Replacement of Headlamp Bulbs

    Replacing of bulbs for high beam and low

    beam headlamp.

    1) Remove the back cover of headlamp.

    2) Remove the bulb clip.

    3) Remove the bulbs for high beam and

    dipped headlamp.

    4) Remove the used bulbs, and replace them

    with new bulbs.

    Fixing point

    3.pdf4.pdf5.pdf1-Introduccion (4).pdf

    3.pdf4.pdf5.pdf1-Introduccion (4).pdf

    3.pdf4.pdf5.pdf1-Introduccion (4).pdf

    3.pdf4.pdf5.pdf1-Introduccion (4).pdfSection Technical Data and Precautions1. Schematic DiagramSchematic Diagram

    3.pdf4.pdf5.pdf1-Introduccion (4).pdfSection Clutch Box

    3.pdf4.pdf5.pdf1-Introduccion (4).pdf Installation of Parking Brakes1. Replacement of Parking Brake Shoes

    3.pdf4.pdf5.pdf1-Introduccion (4).pdf

    3.pdf4.pdf5.pdf1-Introduccion (4).pdf4. Replacement of Headlamp Bulbs