Service Manual Sony Vaio Vgn S

8/13/2019 Service Manual Sony Vaio Vgn S

1/20

S Series

Confidential

Chapter 1. Disassembly & Assembly Guide

1.MS-1-D.1

1-3. Disassembly & Assembly

- Main Section -

MS-1 Main Section Disassembly


2/20

S Series

Confidential

Battery Pack

1) 2)

1.MS-1-D.2

Slide the Battery Lock (L) to the UNLOCK side.With the Battery Lock (R) moved on the UNLOCK side,

remove the Battery Pack.

Battery Pack


3/20

S Series

Confidential

Cover (Memory)

1) 2)

1.MS-1-D.3

Remove the two screws.

*The type of screw differs by model.

Slide the Cover (Memory) toward the front to remove.

*The two detents on the upper side are engaged with the Housing (Bottom).

The Memory and the Wireless LAN Card are located under the Cover in section A.

A

Memory

Wireless LAN Card

Screw:

S240P - B11(Special Screw)

Other - B91 [MA]


4/20S Series

Confidential

Keyboard

1) 2)

1.MS-1-D.4

3)

Remove the nine screws from the back.

Screw:B1Detent

Disengage the two detents with a bamboo spatula, and turnthe Keyboard toward the front.

*The FPC is connected on the back.*Push the detents toward the rear to disengage.

FPC

FPC

Disconnect the FPC.

*Raise the Connector to unlock.

Connector


5/20S Series

Confidential

Palmrest

1) 2)

1.MS-1-D.5

3)

Remove the five screws.

Screw: B1

Disconnect the Harness (two places) and the FFC (two places).

*Pull off the Harness and the FFC upward.

FFC

Disengaging the five detents, remove the Palmrest.

*The detents are engaged toward the outside.

Harness

Remark

Palmrest

1

2 3

4

Raising the Palmrest while sliding it a little in the arrow direction in

the order of 1, 2, 3, 4, disengage the detents.


6/20S Series

Confidential

HDD

1) 2)

1.MS-1-D.6

Disconnect the Connector, and remove the HDD.

*The HDD is removed together with the Bracket (HDD).Remove the two screws.

Screw: B4

HDD

Connector

Bracket (HDD)


7/20S Series

Confidential

Parts of the HDD

1) 2)

1.MS-1-D.7

Remove the four screws, and then the Bracket (HDD).Remove the FPC.

FPC

Bracket

Screw: B8

Remark

Disconnect the Connector portion little by little with a tweezers.

*Be careful not to bend the pins.

C fid ti l


8/20S Series

Confidential

Heatsink

1)

1.MS-1-D.8

Remove the three screws, and then the Heatsink.The Spring is attached under the Screw.

RemarkScrew: Red-B5 / Blue-B4

Heatsink

Confidential1 MS 1 D 9


9/20S Series

Confidential

PC Card Connector

1) 2)

1.MS-1-D.9

3)

Remove the one screw.

Disconnect the Connector, and remove the PC Card Connector.

*The Bracket is removed together.

*The PC Card Connector is located under the Bracket.

Remove the four screws, and then the Bracket.

Connector

Bracket

Screw: B10

PC Card Connector

Bracket

Screw: B4



10/20S Series

Confidential

Optical Disc Drive

1) 2)

1.MS-1-D.10

Remove the four screws.Disconnect the FFC.

*Raise the Connector and release the lock.

Connector

3)

Remove the Optical Disc Drive.

Optical Disc Drive

Screw: B4



11/20S Series

Confidential

IFX-311 Board, IFX-331 Board

1) 2)

1.MS-1-D.11

3)

Slide the both ends of the lock lever in the arrow direction to

unlock, and disconnect the FFC.Remove the three screws, and then the IFX-311 Board.

Remove the Harness (RJ-45/11).

FFC

Lock Lever

Remove the one screw, and then the IFX-331 Board.

IFX-331 Board

Screw: B4Harness (RJ-45/11)

Bluetooth Model4)

Screw: B4

IFX-311 Board

Confidential1 MS-1-D 12


12/20

S Series

Confidential

Parts of the IFX Board

1) 2)

1.MS-1-D.12

3) 4)

Remove the two screws. Remove the Modem Card.

*The Connector is located on the back.

Turn over the IFX-311 Board, and peel off the Sheet.Disconnect the Connector in the arrow direction,

and remove the Harness (RJ-45/11).

Connector

Harness (RJ-45/11)

Screw: B3

Common

Modem Card

IFX-311 BoardConnector

Confidential1 MS-1-D 13


13/20

S Series

Confidential

1)

1.MS 1 D.13

Remove the Bluetooth Module.

*The Connector is located on the back.

*The Coaxial Cable is hooked on the notch.

Parts of the IFX Board

Notch

Bluetooth Model

Connector

Bluetooth Module

2)

Disconnect the Coaxial Cable from the IFX-331 Board and

the Bluetooth Module respectively.

*Disconnect the Connector vertically.

Bluetooth Module

IFX-331 Board

Confidential1.MS-1-D.14


14/20

S Series

CNX-261 Board

1) 2)

1.MS 1 D.14

3)

Remove the two screws.Remove the CNX Board.

*The Connector is fitted in the Escutcheon (L).

Disconnect the FFC.

*Pull it off in the arrow direction.

FFC

Screw: B4CNX BoardConnector

Escutcheon (L )



15/20

S Series

Mother Board -1

1) 1)

2) 3)

Remove the Cover.

Disconnect the Harness (LCD).

*Pull it off upward.Remove the one screw, and then the Bracket.

Bracket

Screw: B4

Remove the one screw.

Screw: B4

Cover

Harness (LCD)

[DEL]6



16/20

S Series

4) 5)

6)

Remove the Mother Board.

*The Connector is fitted in the Escutcheon (R).

Turn over the Mother Board, open the tabs outward (arrow 1), and

pull off the Wireless LAN Card diagonally upward (arrow 2).

Mother Board -2

1

1

2

Tab

7)

Remove the one screw, and then the DC Jack.

Screw: B4

Wireless LAN Card

Remove the four screws and the Spacer (MBX) (one location).

*Remove the Spacer (MBX) using the 4 mm socket wrench.

DC Jack

Screw: B4

Spacer (MBX)

Mother Board

Escutcheon (R)



17/20

S Series

LCD Section

1)

Remove the four screws, and then the LCD Section upward.

Screw: B4

LCD Section


18/20



19/20

S Series

Parts of the Escutcheon (L/R)

1)

Remove the Cover from the Escutcheon (L).

2)

3)

Remove the Kenjington from the Escutcheon (L).

Remove the Cover from the Escutcheon (R).

Cover

Cover

Escutcheon (R)

Escutcheon (L)

Kenjington

Confidential


20/20

S Series

Update History

Date Contents Version No.

[ADD]---Addition [DEL]---Deletion [CHG]---Change [COR]---Correction [MA]---Model Addition

12004.09.17 [MA] (Page 3) 2.00

62005.01.06 [DEL] Parts (Page 15,18) 3.00

Documents

Service Manual Sony Vaio Vgn S