-
7/29/2019 Valve Sizing.xls
1/6
Valve Szg_cylinders
TECHNICAL SERVICES
VALVE SIZING FOR CYLINDER APPLICATIONS
BORE DIA. (INCHES) : 0 CYLINDER VOLUME : 0.00 cubic inches
CYL. STROKE (INCHES) : 0 PISTON AREA : 0.00 square inches
ROD DIA. (INCHES) : 0 PISTON AREA : 0.00 square inches
(ROD END)
STROKE TIME (SECONDS) : 0
(1 WAY - EXT. OR RETR.) EXTEND FORCE : 0 lbs
INLET PRESSURE (PSIG) : 0 RETRACT FORCE : 0 lbs
VALVE PRESS. DROP* : 0 FLOW : #DIV/0! SCFM
*Maximum allowable drop for application REQUIRED Cv #DIV/0!
Cv
U.S.A. - 11/03 Copyright 2003, ROSS CONTROLS RC-E-S10003
Page 1
-
7/29/2019 Valve Sizing.xls
2/6
Valve Szg_motors
TECHNICAL SERVICES
VALVE SIZING FOR AIR MOTOR APPLICATIONS
INLET PRESSURE (PSIG) : 0
VALVE PRESS. DROP : 0 REQUIRED Cv : #DIV/0! Cv
FLOW (SCFM) : 0
U.S.A. - 11/03 Copyright 2003, ROSS CONTROLS RC-E-S1000
Page 2
-
7/29/2019 Valve Sizing.xls
3/6
CFM to SCFM
TECHNICAL SERVICES
Conversion from cfm to scfm
OPERATING PRESSURE: 0
CFM (cubic feet per
minute at above pressure): 0
SCFM : 0.00
U.S.A. - 11/03 Copyright 2003, ROSS CONTROLS RC-E-S10003
Page 3
-
7/29/2019 Valve Sizing.xls
4/6
TECHNICAL SERVICES
Conversion from SCFM to CFM
OPERATING PRESSURE: 0
SCFM (cubic feet per minute
at standard pressure): 0
NOTE: Standard pressure is CFM : 0.00
14.7 psia.
U.S.A. - 11/03 Copyright 2003, ROSS CONTROLS RC-E-S10003
-
7/29/2019 Valve Sizing.xls
5/6
Total Cv
TECHNICAL SERVICES
Calculation of total Cv (components in series)
Component 1 0
Component 2 0 Cv total = #DIV/0!
INSTRUCTIONS: Enter the individual Cv values in the blanks for
component 1 and component 2.
The answer will pop up in the Cv total blank.
If you have more than two components:
A) Enter the first two values.
B) Take the answer of the first two values and enter it in the
blank for component 1.
C) Next enter the third value in the blank for component 2. The
new answer is the total
of all three. This can be repeated over and over for additional
components.
Page 5
-
7/29/2019 Valve Sizing.xls
6/6
Total Cv
Page 6
