Assembling/Dismanteling Method of the Socket

1. Recommended Tools

1. Hex Nut Driver [Recommended Model : Wiha PicoFinish 265P 4,0X60]2. Tweezers

2. Dismantling Method

2-2. Remove the bolts with the hex nut driver

2-1. Picture with the bolts holding the Adapter together

2-3 Picture with the Adapter with the bolts removed

1.Separate the Top and the Bottom of the Adapter

2. Dismantling Method

4-1. Carefully remove the PAD from the Socket

4-2. Picture of the Rubber PAD removed from the Socket

3. Separate the PCB and the Socket

3. Assembling Method

1-1. Check the correct direction of the Rubber PAD by com-paring the sizes of the holes [The Compass Logo is located at the front]

2-1. Check the sizes of holes in the PCB, then place the PCB onto the Socket 3. Finally, screw the bolts back on to the Adapter

1-2.Using tweezers, set the Rubber PAD onto the Socket, Compass Logo facing down (The direction of the PAD is very important)

PCB hole