Upload
abel-arroniz
View
25
Download
0
Embed Size (px)
Citation preview
2.1 Materiales: cold caustic, botella de coca cola, cortador de cable, guantes de vinil,Cable trenzado calibre 18, regla (Nota: la botella de coca cola sin foto)
The Klein Tools - Katapult Wire Stripper/cortador harán esta tarea mucho más fácil
El uso de cable de cobre desnudo trenzado ahorrará varios pasos en este proceso
2.2 Mide 5 pulgadas de alambre
2.3 Corta con el cortador de alambre
2.4 colocar a un lado el alambre
2.5 Repetir la operación 25 ocasiones
2.6 Doblar el alambre en forma de gancho. Destrence y las puntas de ambos extremos del cable
2.7 Haz lo mismo con el resto de cables
2.8 Inserta el cable en la botella de coca cola(note: incorrect bottle pictured)
2.9 Place remaining wires into coca cola bottle(note: incorrect bottle pictured
2.10 Spray cold caustic liquid several times into the bottle. You want to coat the wires and minimize the amount of liquid on the bottom submerging the wires. The submerged wire will not nanocoat.
2.11 Secure cap onto coca cola bottle
2.12 Shake coca cola bottle and swish liquid around to coat the wires
2.13 Leave container to sit for several hours. Tilt container to prevent wires being submerged in liquid if necessary. Time pictured- zero hours
Time pictured – One hour
Time pictured Two Hours
Time Pictured: Four Hours
2.14 Cut open the Coca Cola bottle
2.15 Set the wires out to dry
Detail view of nanocoated copper wire