בוחן - BOOTUP

8/3/2019 BOOTUP - בוחן

http://slidepdf.com/reader/full/-bootup 1/4

Boot-upבוחן-1. Before installing a new, upgraded version of the IOS, what should be checked on the router, and which command

should be used to gather this information? (Choose two.)

A. the amount of available ROMB. the amount of available flash and RAM memoryC. the version of the bootstrap software present on the router D. show version

E. show processes

F. show running-config

2. Which command is used to copy the configuration from RAM into NVRAM?

A. copy running-config startup-config

B. copy startup-config: running-config:

C. copy running config startup config

D. copy startup config running config

E. write terminal

3. Which command is used to load a configuration from a TFTP server and merge the configuration into RAM?

A. copy running-config: TFTP:

B. copy TFTP: running-config

C. copy TFTP: startup-config

D. copy startup-config: TFTP:

4. A system administrator types the command to change the hostname of a router. Where on the Cisco IFS is thatchange stored?

A. NVRAMB. RAM

C. FLASHD. ROME. PCMCIA

5. Which of the following IP addresses fall into the block of 115.64.4.0/22? (Choose three.)

A. 115.64.8.32B. 115.64.7.64C. 115.64.6.255D. 115.64.3.255E. 115.64.5.128F. 115.64.12.128

153-774123211http://www.iitc.co.ilפקס:077-4123211טלפון:52522רמת גן3החילזון 1

http://www.iitc.co.il/





6. Refer to the diagram. What is the largest configuration file that can be stored on this router?

A. 4 MBB. 51 MBC. 64 MBD. 12 MBE. 16 MBF. None of the above

7. Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. Whenthe router starts, it enter the system configuration dialog as shown. What is the caust of the problem?

A. The network administrator faled to save the configuration.B. The configuration register is set to 0x2100.C. The boot system flash command is missing from the configuration.D. The configuraiton register is set to 0x2102.E. The router is configured with the boot system startup command.

8. A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results

of making this change? (Choose two.)

A. The IOS image will be ignored.B. The router will prompt to enter initial configuration mode.C. The router will boot to ROM.D. Any configuration entries in NVRAM will be ignored.E. The configuration in flash memory will be booted.

9. Which command displays CPU utilization?







A. show protocols

B. show process

C. show system

D. show version

10. What should be done prior to backing up an IOS image to a TFTP server? (Choose three.)

A. Make sure that the server can be reached across the network.B. Check that authentication for TFTP access to the server is set.C. Assure that the network server has adequate space for the IOS image.D. Verify file naming and path requirements.E. Make sure that the server can store binary files.F. Adjust the TCP window size to speed up the transfer.

11. Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown?(Choose two.)

A. Router1 has specific boot system command that instruct it to load IOS from TFTP server.B. Router1 is acting as a TFTP server for other routers.C. Router1 cannot locate a valid IOS image in flash memory.D. Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E. Cisco routers will first attempt to load a image from TFTP for management purposes.







תשובות

B,D1

A2

B3

B4

B,C,E5

D6

A7

B,D8

B9

A,C,D10

A,C11





Documents

בוחן - BOOTUP