Upload
advocate
View
217
Download
0
Embed Size (px)
Citation preview
8/7/2019 LO 10-3530-205-12-2
http://slidepdf.com/reader/full/lo-10-3530-205-12-2 1/4
LO10-3530-205-12-2
LUBRICATION ORDER
6 AUGUST 1985
CLOTHING REPAIR SHOP, TRAILER MOUNTED
MODEL: CRS
NSN: 3530-01-133-3494
DARNING SEWING MACHINECHANDLER MODEL NO. 678HD
Reference TM10-3530-205-14 and C9100-IL
Intervals (on-condition or hard time) and the related task-hour times are based on normal operation. The task-hour time specified is the time you need to do all theservices prescribed for a particular interval. On-condition(OC) oil sample intervals shall be applied unlesschanged by Army Oil Analysis Program (AOAP)laboratory. Change the hard time interval if yourlubricants are contaminated or if you are operating theequipment under adverse operating conditions includinglonger-than-usual operating hours. The hard timeinterval may be extended during periods of low activity. Ifextended adequate preservation precautions must betaken. Hard time intervals will be applied in the eventAOAP laboratory support is not available.
Clean all lubrication points with dry cleaning solven(SD), type II or equivalent. Dry before lubricating. Thelowest level of maintenance to lubricate a point isindicated by one of the following:
(C) Operator/Crew or (O) OrganizationaMaintenance.
You can help improve this manual. If you find anymistakes or if you know of a way to improve proceduresplease let us know. Mail your letter or DA Form 2028(Recommended Changes to Publications and BlankForms) direct to: Commander, US Army Troop SupporCommand, ATTN: AMSTR-MPS, 4300 GoodfellowBlvd, St. Louis, MO 63120-1798. A reply will befurnished to you.
LUBRICANT • INTERVAL INTERVAL • LUBRICANT
Card 1 of 2
8/7/2019 LO 10-3530-205-12-2
http://slidepdf.com/reader/full/lo-10-3530-205-12-2 2/4
LO 10-3530-205-12-2
LUBRICANT * INTERVAL INTERVAL * LUBRICANT
UNDERSIDE OF BEDMACHINE TILTED BACK
TOTAL TASK-HR TOTAL TASK-HR
INTERVAL TASK-HR INTERVAL TASK-HR
4 1.0 40 1.0
LUBRICANTS EXPECTED TEMPERATURES INTERVALS
OE/HDO-10 Lubricating Oil, All Temperatures(MIL-L-2104) General Purpose Intervals given are in
hours of normal operationGAA Grease Automotive All Temperatures(MIL-G-10924) and Artillery
NOTES
1. Lubricate oil points with two or three drops ofOE/HDO-10 every four hours.
2. Lubricate points with two or three drops ofOE/HDO-10 every 40 hours.
3. Remove old grease and clean with drycleaning solvent P-D-680. Allow to dry. Coatgear with GAA grease.
4. Remove bobbin. Lubricate pin. Reinstallbobbin.
5. Remove screws and cover. Lubricate. Reinstallcover and screws.
Copy of this Lubrication Order will remain with theequipment at all times, instructions contained herein aremandatory.
By Order of the secretary of the Army:
JOHN A. WICKHAM, JR.General, United States Army
Chief of Staff Official:
DONALD J. DELANDROBrigadier General, United States Army
The Adjutant General
DISTRIBUTION:
To be distributed in accordance with DA form12-25A, Operator Maintenance requirements for Clothingand Textile Repair.
∗U.S. GOVERNMENT PRINTING OFFICE: 1985-461-026/20325
Card 2 of 2