PRIMASOLLEVELVPRIMASOLV60

8/3/2019 PRIMASOLLEVELVPRIMASOLV60

1/6

Safety data sheet

Page: 1/6

BASF Pakistan (Private) Limited Safety data sheetDate / Revised: 19.06.2007 Version: 1.0Product: Primasol Level V (Primasol* V)

(30049690/SDS_TEX_PK/EN)

Date of print 23.11.2011

1. Substance/preparation and company identification

Primasol Level V (Primasol* V)

Use: auxiliary / finishing agent for the textile industry

Company:BASF Pakistan (Private) Limited

46-A, Block 6, P.E.C.H.S, Karachi-75400PAKISTANContact address:Telephone: +92 21 111-550550Telefax number: +92 21 4547-815 / 4546-552E-mail address: [email protected]

Emergency information:International emergency number:Telephone: +49 180 2273-112

2. Composition/information on ingredients

Chemical nature

polyacrylate, in water

3. Hazard identification

No particular hazards known.


2/6

Page: 2/6




4. First-aid measures

General advice:Remove contaminated clothing.

If inhaled:If difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and seek medicalattention.

On skin contact:Wash thoroughly with soap and water.

On contact with eyes:Wash affected eyes for at least 15 minutes under running water with eyelids held open.

On ingestion:Rinse mouth and then drink plenty of water.

Note to physician:Treatment: Treat according to symptoms (decontamination, vital functions), no known specificantidote.

5. Fire-fighting measures

Suitable extinguishing media:water spray, dry extinguishing media, foam

Specific hazards:harmful vapoursEvolution of fumes/fog. The substances/groups of substances mentioned can be released in case offire.

Further information:Contaminated extinguishing water must be disposed of in accordance with official regulations.

6. Accidental release measures

Personal precautions:Use personal protective clothing.

Environmental precautions:Contain contaminated water/firefighting water. Do not discharge into drains/surfacewaters/groundwater.

Methods for cleaning up or taking up:For large amounts: Pump off product.For residues: Pick up with suitable absorbent material. Dispose of absorbed material in accordancewith regulations.

Additional information: High risk of slipping due to leakage/spillage of product.


3/6

Page: 3/6




7. Handling and storage

Handling

No special measures necessary provided product is used correctly.

Protection against fire and explosion:No special precautions necessary.

Storage

Further information on storage conditions: Keep container tightly closed and in a cool place.

Protect from temperatures above: 40 C

8. Exposure controls and personal protection

Components with workplace control parameters

acrylamide, 79-06-1; (Content (W/W): < 40 PPM)TWA value 0.03 mg/m3 (ACGIHTLV)Skin Designation (ACGIHTLV)The substance can be absorbed through the skin.

Personal protective equipment

Respiratory protection:Respiratory protection not required.

Hand protection:Chemical resistant protective glovesSuitable materials also with prolonged, direct contact (Recommended: Protective index 6,corresponding > 480 minutes of permeation time according to EN 374):e.g. nitrile rubber (0.4 mm), chloroprene rubber (0.5 mm), polyvinylchloride (0.7 mm) and otherSupplementary note: The specifications are based on tests, literature data and information of glove

manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g.temperature) it must be considered, that the practical usage of a chemical-protective glove inpractice may be much shorter than the permeation time determined through testing.Manufacturer's directions for use should be observed because of great diversity of types.

Eye protection:Safety glasses with side-shields.

General safety and hygiene measures:Handle in accordance with good industrial hygiene and safety practice. Wearing of closed workclothing is recommended.

9. Physical and chemical properties

Form: liquid


4/6

Page: 4/6




Colour: colourlessOdour: product specific

pH value: 7 - 8.5(20 C)(measured with the undilutedsubstance)

solidification temperature: approx. 0 Cboiling temperature: approx. 100 C

Flash point: > 100 C (DIN 51758)Flammability: not self-igniting

Ignition temperature: > 200 C (DIN 51794)Explosion hazard: not explosive

Vapour pressure: approx. 24 mbar(20 C)

Density: approx. 1.1 g/cm3(20 C)

Solubility in water: completely soluble(20 C)

Miscibility with water:miscible in all proportions

Viscosity, dynamic: approx. 4,000 mPa.s(20 C)

(DIN EN ISO 2555)

10. Stability and reactivity

Hazardous reactions:No hazardous reactions when stored and handled according to instructions.

Hazardous decomposition products:

No hazardous decomposition products if stored and handled as prescribed/indicated.

11. Toxicological information

Acute toxicity

LD50 rat (oral): > 5,000 mg/kg

rat (by inhalation): 7 h (IRT)No mortality within the stated exposition time as shown in animal studies.

Irritation

Primary skin irritation rabbit: non-irritant (Draize test)


5/6

Page: 5/6




Primary irritations of the mucous membrane rabbit: non-irritant (Draize test)

12. Ecological information

Ecotoxicity

Toxicity to fish:LC50 (96 h) > 100 mg/l, Leuciscus idusThe product has not been tested. The statement has been derived from products of a similarstructure and composition.

Microorganisms/Effect on activated sludge:

> 2,000 mg/l (DEV-L2)Inhibition of degradation activity in activated sludge is not to be anticipated during correctintroduction of low concentrations.

Persistence and degradability

Elimination information:< 20 % COD reduction (OECD 302B; ISO 9888; 88/302/EEC,part C) Poorly eliminated from water.

sum parameter

Chemical oxygen demand (COD): 160 mg/g

Biochemical oxygen demand (BOD): 15 mg/g

Other adverse effects

Adsorbable organically-bound halogen (AOX):This product contains no organically-bound halogen.

Additional information

Other ecotoxicological advice:Do not release untreated into natural waters.

13. Disposal considerations

Must be dumped or incinerated in accordance with local regulations.A waste code in accordance with the European waste catalog (EWC) cannot be specified, due todependence on the usage.Observe national and local legal requirements.

Contaminated packaging:Uncontaminated packaging can be re-used.Packs that cannot be cleaned should be disposed of in the same manner as the contents.

14. Transport information

Domestic transport:Not classified as a dangerous good under transport regulations


6/6

Page: 6/6




Sea transportIMDG

Not classified as a dangerous good under transport regulations

Air transportIATA/ICAO

Not classified as a dangerous good under transport regulations

15. Regulatory information

Regulations of the European union (Labelling)

The labelling is based on our own experience.not subject to labelling

Other regulations

16. Other information

textile industry Information on intended use: This product is of industrial quality and unless otherwisespecified or agreed intended exclusively for industrial use. This includes the mentioned andrecommended usage. Any other intended applications should be discussed with the manufacturer. Inparticular this concerns the application for products that are the object of special standards andregulations.

Vertical lines in the left hand margin indicate an amendment from the previous version.

The data contained in this safety data sheet are based on our current knowledge and experience anddescribe the product only with regard to safety requirements. The data do not describe the product'sproperties (product specification). Neither should any agreed property nor the suitability of the product forany specific purpose be deduced from the data contained in the safety data sheet. It is the responsibilityof the recipient of the product to ensure any proprietary rights and existing laws and legislation areobserved.

Documents

PRIMASOLLEVELVPRIMASOLV60