Upload
quan-tran
View
13
Download
1
Embed Size (px)
Citation preview
Installation configurations
Flat filters, e.g. for ceiling
installation
Flat filters housed in
exchangeable EMW plastic
frames
Flat filters in combined
filter systems
Z - line filters
Pocket filters for coarse
dust removal
Dimensions
Standard roll sizes:
- 2000 x 20000 mm
- 2000 x 40000 mm
Wide range of cut-to-size
sections available on
request
SYNFASAN
SYNFASAN
U15 - U50 are outlet-side compressed polyester nonwoven filter media available in
Filter Classes G2 - G4 according to EN 779. SYNFASAN
is used for coarse dust removal in
prefiltration, as a cut-to-size flat panel or as a "Z" pleated filter housed in an exchangeable plastic
frame. SYNFASAN
is also available in an optional version incorporating a plastic reinforcing grid
on the outlet side. SYNFASAN
media are environment-friendly products made without bonding
agents of any kind.
SYNFASAN
C2 - C5G are synthetic-fibre nonwovens compressed on their outlet side to varying
degrees of compression, satisfying EN 779 Filter Classes up to F5. SYNFASAN
C3 incorporates
an additional nonwoven protective layer on its outlet side as standard equipment. SYNFASAN
C5G is adhesive-activated for improved dust holding capacity and also incorporates a reinforcing
grid. It is ideal for use e.g. as a ceiling filter in application stations for enamels and other
coatings.
CHARACTERISTICS
Filter Classes G3 M5 available (EN 779)
Dependable service even at 100% relative humidity
Max. service temperature: 100 C
Fully incinerable
APPLICATION FIELDS
Inlet air filtration for turbomachinery
Heating, ventilation, air conditioning (HVAC)
Chemical and pharmaceutical plants
Dust / fume removal hoods at workplaces
Enamelling lines
Technical Data
Technical data* of SYNFASAN coarse dust filters according to EN
779:
SYNFASAN
type
Thickness[m
m]
Face Velocity
[m/s]
P initial[Pa] P final[Pa] Filter class
EN 779
Dust holding
capacity **
[g]
U15 10 1.5 27 250 G3 330
U25T 15 1.5 30 250 G3 400
U29B 20 1.5 50 250 G4 460
U35 20 1.5 50 250 G4 460
U50 20 1.5 100 250 G4 450
Technical data* of Thermobond filters according to EN 779:
THERMOBON
D
Thickness[m
m]
Face Velocity
[m/s]
P initial[Pa] P final[Pa] Filter class
EN 779
Dust holding
capacity **
[g]
Z-Line 22
pleats
4 1 55 250 G4 200
Technical data* of SYNFASAN fine filters according to EN 779:
SYNFASAN
type
Thickness[m
m]
Face Velocity
[m/s]
P initial[Pa] P final[Pa] Filter class
EN 779
Dust holding
capacity **
[g]
C2 10 0.25 15 450 F5 350
C3 16 0.25 22 450 F5 400
C5G 20 0.25 35 450 F5 350
* : The data given are typical figures. The exact operating data in a specific application may vary
in accordance with dust composition as well as other local conditions.
1 / 2
** : Dust holding capacity was measured at the recommended final pressure differential.
Depending on the installation configuration and other details of the specific application, filters
may be operated to higher or lower final pressure differentials; the dust holding capacity will
change accordingly.