12/10/2016
1
TL2101 Mekanika Fluida I
Benno Rahardyan
Pertemuan 4
Mg Topik Sub Topik Tujuan Instruksional (TIK)
Pengantar Definisi dan sifat-sifat fluida,
berbagai jenis fluida yang
berhubungan dengan bidang TL
Memahami berbagai
kegunaan mekflu
dalam bidang TL
Pengaruh tekanan Tekanan dalam fluida, tekanan
hidrostatik
Mengerti prinsip-2
tekanan statitka
Pengenalan jenis
aliran fluida
Aliran laminar dan turbulen,
pengembangan persamaan
untuk penentuan jenis aliran:
bilangan reynolds, freud, dll
Mengerti, dapat
menghitung dan
menggunakan prinsip
dasar aliran staedy state
Idem Idem Idem
Prinsip kekekalan
energi dalam
aliran
Prinsip kontinuitas aliran,
komponen energi dalam aliran
fluida, penerapan persamaan
Bernoulli dalam perpipaan
Mengerti, dapat
menggunakan dan
menghitung sistem prinsi
hukum kontinuitas
Idem Idem + gaya pada bidang terendam Idem
Aplikasi kekekalan
energi
Aplikasi kekekalan energi dalam
aplikasi di bidang TL
Latihan menggunakan
prinsip kekekalan
eneri khususnya dalam
bidang air minum
UTS - -
12/10/2016
11
(i) Water flows in a circular pipe which increases in diameter from 400mm at point A to 500mm at point B. Then pipe then splits into two branches of diameters 0.3m and 0.2m discharging at C and D respectively. If the velocity at A is 1.0m/s and at D is 0.8m/s, what are the discharges at C and D and the velocities at B and C?
(ii) If point A is 5m higher than point B and the pressure at A is 15kN/m2, what is the pressure at point B?
12/10/2016
13
A pipe which is carrying water turns through 45o in the horizontal plane, at the same time it reduces diameter from 0.55m at the entrance to the bend to 0.25m at the exit. The water is measured as flowing at the rate of 400 litres/s with a pressure at the entrance of 1.5 bar.
Neglecting any head loss due to friction,
calculate the force exerted by the water on the bend, andits direction of application.