NTP_SERVER=my.pool.ntp.org. NTP_SERVER=my.pool.ntp.org. NTP_SERVER =my.pool.ntp.org. XTRA_SERVER_1=http://xtra1.gpsonextra.net/xtra2.bin XTRA_SERVER_2=http://xtra2.gpsonextra.net/xtra2.bin XTRA_SERVER_3=http://xtra3.gpsonextra.net/xtra2.bin # DEBUG LEVELS: 0 - none, 1 - Error, 2 - Warning, 3 - Info # 4 - Debug, 5 - Verbose DEBUG_LEVEL = 3 # Intermediate position report, 1=enable, 0=disable INTERMEDIATE_POS=0 # supl version 1.0 SUPL_VER=0x10000 # Error Estimate # _SET = 1 # _CLEAR = 0 ERR_ESTIMATE=0 # GPS Capabilities bit mask # SCHEDULING = 1 # MSB = 2 # MSA = 4 # ULP = 0x20 # default = MSA | MSB | SCHEDULING | ULP CAPABILITIES=0x07 # Accuracy threshold for intermediate positions # less accurate positions are ignored, 0 for passing all positions # ACCURACY_THRES=5000 ################################ ##### AGPS server settings ##### ################################ # FOR SUPL SUPPORT, set the following # SUPL_HOST=supl.host.com or IP # SUPL_PORT=1234 SUPL_HOST=supl.google.com SUPL_PORT=7276 # FOR C2K PDE SUPPORT, set the following # C2K_HOST=c2k.pde.com or IP # C2K_PORT=1234 ################################ # Sensor Settings ################################ # Needs to be set explicitly based on sensor # There is no default value. #GYRO_BIAS_RANDOM_WALK= SENSOR_ACCEL_BATCHES_PER_SEC=2 SENSOR_ACCEL_SAMPLES_PER_BATCH=5 SENSOR_GYRO_BATCHES_PER_SEC=2 SENSOR_GYRO_SAMPLES_PER_BATCH=5 # Sensor Control Mode (0=AUTO, 1=FORCE_ON)SENSOR_CONTROL_MODE=0 # Enable or Disable Sensors for GPS use (0=Enable, 1=Disable) SENSOR_USAGE=1 # Choose GSIFF sensor provider (1=DSPS, 2=Android NDK) SENSOR_PROVIDER=1 ################################ # Indoor Positioning Settings ################################ # 0: QUIPC disabled, 1: QUIPC enabled, 2: forced QUIPC only QUIPC_ENABLED = 0 ################################ # EXTRA SETTINGS ################################ # Enable or Disable Wiper (1=Enable, 0=Disable) ENABLE_WIPER=0 #################################### # LTE Positioning Profile Settings #################################### # 0: Enable RRLP on LTE(Default) 1: Enable LPP_User_Plane on LTE LPP_PROFILE = 0