Upload
christian-icaza-samaniego
View
216
Download
0
Embed Size (px)
Citation preview
7/27/2019 1997Nissan200SX
1/1
Nissan 200SX 1997
WWW.WIREMAGIC.COM
Wire/F unction Colour L ocation / Descr iption Polar i ty
Installation type: Remote start / securi ty / GPS
White or Green Ignition harness +12 VOLTS
Black/red Ignition harness +IGNITION
Black/pink Ignition harness +ACCESSORY
Black/white Ignition harness +STARTER
Black/blue* Ignition harness +STARTER 2
Green At distributor on engine ACTACH
Gray Driver's kick or keyless mod** -LOCK
Purple Driver's kick or keyless mod** -UNLOCK
Red/white In driver's kickpanel -DOORPIN
Pink/black At pin or Alarm*** -HOODPIN
Red In driver's kickpanel -TRUNK PIN
Manual releaseTRUNK RELEASE
Lt.green/red In driver's kickpanel -FACTORY ARM
Green/yellow In driver's kickpanel -FACTORY DISARM
Green/white At switch above brake pedal +BRAKESWITCH
Red/green At switch or driver's kick +PARKLIGHTS
Yellow/black or Lt.green At switch or instrument panel -HAND BRAKE
Green/yellow At steering column -HORN
Black/red At switch on top of clutch pedal TYPE 2CLUTCH SWITCH
Blue At switch in driver's door REV POLDRIVER WINDOW UP
Green At switch in driver's door REV POLDRIVER WINDOW DOWN
Red/white At switch in driver's door REV POLPASSENGER WINDOW UP Red/black At switch in driver's door REV POLPASSENGER WINDOW DOWN
Yellow/red At switch in driver's door REV POLLEFT REAR WINDOW UP
Yellow/black At switch in driver's door REV POLLEFT REAR WINDOW DOWN
Green/white At switch in driver's door REV POLRIGHT REAR WINDOW UP
Green/black At switch in driver's door REV POLRIGHT REAR WINDOW DOWN
Red/yellow & Pink/blue At light switch harness +HEADLIGHTS
Green/white In driver's kickpanel +REVERSE LIGHTS
Red/yellow At dimmer switch harness DIMMER
Purple/red Pin 26 at ECM in center console VSS WIRE
Blue Ignition harness +KEY SENSE
* This wire must be connected for remote start.** Keyless entry module is located on the right side of the steering column*** Alarm module is located above the driver's kick panel behind the junction block.
Vehicle note:
Wednesday, Apr i l 10, 2002 Page 1 of 1
Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuitbefore connecting to it. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this
document and/or software assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the soleresponsibility of the installer performing the work and Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resultingfrom any type of installation, whether performed properly, improperly, or in any other way. The information supplied is a guide only. Copyright 1998-2001 Wiremagic.com Corporation. All rights reserved.