Lab 8 On-Chip Bus

R91921012 林政廷 R91921061 林耿賢

Add verilog file to this project

CFGLNK Jumper

Download(execute procards.exe)

Logic Module0 Architecture

0xC000_000CLM0 0xC000_0000LM1 0xD000_0000LM2 0xE000_0000LM3 0xF000_0000

0xC200_0000~0xC20F_FFFF 0xC000_0000 0xC000_0004

LM_LOCK: 0x C000_0008

0xC000_00140xC000_0010

My IP

0xC300_0000

Integrator Memory Map

Logic Module Registers

Clock Generator

Clock control signal assignment(1)

Before writing to the oscillator registers, you must unlock them by writing the value 0x0000A05F to the LM_LOCK register. After writing the oscillator register, relock them by writing any value other than 0x0000A05F to the LM_LOCK register.

Clock control signal assignment(2)

LEDS

There are eight general-purpose green LEDs. These are lit by driving the associated LED output pin LOW.

A red LED is also provided to indicate a user-defined error condition. The Example 2 FPGA configuration supplied with the logic module provides the register LM_LEDS to control the LEDs

Reference Integrator/LM-XCV600E+ Integrator/LM-EP20K600E+ User Guide

AMBA Specification(Rev 2.0)