Car Alarm Eng

Embed Size (px)

Citation preview

  • 7/30/2019 Car Alarm Eng

    1/5

    USER MANUAL

    Lock Unlock Silent Sound

    ARM

    Press button (lock) button on the remote control transmitter will arm the alarm system

    automatically.

    The parking light will blink once, the siren will chirp once, the door will be locked, After the

    arming delay time 3 seconds, ACC/doors/footbrake/shock sensor will work for protection, the status LED

    will flash to indicate the alarm system is armed.

    DISARM

    Press the (unlock) button on the remote control transmitter will disarm the alarm system

    automatically. Upon pressing the button, you will observe the following.

    The parking lights will blink twice, the siren will chirp twice, the door will be unlocked, LED

    will be off. If the car was unlocked by the transmitter and unattended for a period of 25 seconds, the

    system will lock back the doors and will rearm.

    SILENT ARM

    Press (SILENT) button on the remote control transmitter will arm the alarm system withoutsiren chirping. The parking lights will blink once, the doors will be unlocked. After the delay time 3

    seconds the system will go to mute arm status, the LED will flash to indicate the alarm system is armed.

    CAR FINDING

    When armed, pressing the (Lock) button for 2 seconds will blink the parking lights 15

    seconds and sound the siren for 15 sounds continuously. Press the button again will stop blinking and

    sounding. The alarm system still in armed. When armed, pressing the (SILENT) button for 2

    seconds will blink the parking lights 15 seconds continuously, the siren will not sound. Press the button

    again will stop blinking. The alarm system still in armed.

    When disarmed or armed, press (Sound) button will blink the parking lights and sound the

    siren for 15 seconds.

    FUNCTIONS AND FEATURES OPERATION

    1. Inarmed.

    When armed, if somebody attempts to open the door or attempts to driver away the car will

    trigger the system to alarm for 40 seconds. The siren will chirp and parking lights will blink, the engine is

    immobilized. After then the system will go back to armed status automatically.

    2. Stereo sets protection

  • 7/30/2019 Car Alarm Eng

    2/5

    The system will protect from unauthorized person who intend to take out your stereo sets. Upon

    stereo sets being removed the siren and parking lights will be activated to alarm. In case stereo sets

    protection feature did not in use, blue/red wire must connect to ground.

    3. Auto re-lock and re-arm

    When the car was unlocked by the transmitter and unattended for a period of 25 seconds, the

    system will lock back the doors and rearm the system.

    4. Siren pause.

    When the system is triggered to alarm, the siren will chirp. Press the lock or mute button will

    pause the siren chirping. The alarm system will remain in armed.

    5. Triggering indentify.

    When armed, any impact/knock, open the door, ignition on, will trigger the system to alarm.

    When the car was impacted the system will alarm for 5 seconds for the first attempt. And the

    second attempt will trigger the system to alarm for 30 seconds. When the system was triggered by car

    door, ignition on, or footbrake, the siren will keep chirping.

    6. Shock sensor by pass mode

    When the system is armed (chirping arm and silent arm) within 5 seconds, press LOCK or

    SILENT button to bypass the shock sensor. The parking lights will blink 3 times to acknowledge your

    commend. This bypass will be cancelled immediately upon pressing the (unlock) button.

    7. Trunk release.

    Press the c? button for 2 seconds to release the trunk.. The trunk also can be released by TRUNK

    RELASE button if there is any on the remote transmitter.

    8. Manual lock/unlock

    Manually operate the door lock switch on the driver door will also lock/unlock the system, (no

    matter the door is closed properly)

    9. Door lock automatically

    When driving, press or button will unlock or unlock the central door locking system

    without activating the alarm system.

    When car doors are closed properly, ignition on, after the delay time 5 seconds then step the

    footbrake the car doors will be locked automatically.

    When parking, take the car key off, the car doors will unlocked automatically.

    This is a programmable feature. To program this feature on, ignition on, then press the button

    for 2 seconds, the siren will chirp twice to acknowledge this feature. Press again the button again for 2

    seconds will cancel this feature, the siren will only chirp once.

    10. Anti-hijacking

    When driving, ignition on, then press button, the parking lights will blink continuously and

    quickly. Press the button within 30 seconds will go into anti-hijacking mode. Before engine cut off thesiren will chirp and parking lights will blink for 40 seconds, unless press button to disarm.

    11. Carovertake

  • 7/30/2019 Car Alarm Eng

    3/5

    When driving, press the button, the siren will chirp for 15 second and parking lights will

    quickly blink. Press the button again will pause the function.

    12. Door not properly closed warning

    Before driving, if the door is not properly closed , the parking light will blink for 30 seconds.

    Before driving, if the door is not properly closed and key is ON position, the parking lights will

    keep blink until door is closed properly.

    To program this feature ON, turn on the ignition key and press button for 2 seconds, system

    will acknowledge with 2 chirp sounds. Press button again for 2 seconds will cancel this feature with

    response of one chirp sound.

    If the car door is not closed properly, upon pressing the button , the system will chirp the

    siren five times as warning. Alarm arm-time is automatically extend to 30 seconds. The siren will be

    triggered if door is still open after 30 delay times. You should disarm the system and closed the door

    properly. This is desired for some vehicles with extended roof lamp to disable the door not properly

    closed warning.

    13. Reverse beeper feature

    Upon ignition on and gear switched to reverse, the siren will continuously chirp as long as gear

    put into reverse. In case you need to turn off this reverse beeper, press the button once to temporary

    by passed until the next transition of ignition key.

    14. Intruding reminding

    When armed, if door/footbrake/ACC/trunk/hook/shock sensor was triggered, when disarm the

    system the siren will chirp five times as reminding.

    15. Arm reminding

    When parking, if the driver leaves the car for 10 seconds, the parking light will blink 3 times as

    remind to arm the system.

    16. Override switch

    In the event the transmitter is lost or inoperable, the system can be disarmed by manual override

    switch. Trun the ignition key to ON, then press the override switch.

    17. LED indicator

    Arm status: LED is flashing.

    Alarming/valet mode: LED is on.

    18. Ignition cut off

    With the ignition off relay, It will temporary cut of engine ignition circuit when alarming, the

    engine will be immobilized.

    19. Door switch anti-false triggering

    When armed, if door/trunk/engine hook is opened then closed again, the system will alarm for a

    period of 40 seconds. In case the door is opening or door switchis faulty, the system will alarm foraperiod of 4 minutes then stop alarming.

    21. Valet / service mode

  • 7/30/2019 Car Alarm Eng

    4/5

    This feature is available in your system, while you have to hand your car for valet parking or

    servicing. In this mode, system disables all functions except you are allowed to operate the central door

    locking system by the LOCK and UNLOCK buttons of the transmitter only. The system can be

    programming to enter into valet/service mode the following steps: Turn on the ignition key to ON

    position, press and hold override switch for 5 seconds. System will acknowledge with 2 chirp sounds.

    Press the override switch 5 seconds again to cancel the valet mode with response of one chirp sound.

    22. How to learn a new code of transmitters.

    Step on the foot brake, then put the car key into the key lock, turn the key from OFF to ON 8

    times, the siren would chirp once and parking light is ON. The system will in the status of learning the

    new code, then press any key of the transmitter, when the siren chirp once. The learning is success. The

    system can learn 4 transmitters, and after it success to learn, it needs 5 seconds to learn the next one.

    Overtime or after leaning 4 transmitters, the siren will chirp 3 times, the parking light will gleam 3 times

    then the system will exit learning status.

  • 7/30/2019 Car Alarm Eng

    5/5